Votes - 2, Average rating: 3.5 ( )

Manafacture: Thermador File size: 591 kb File name: Language of manual:

Turn all burners on HI setting for 15 - 20 minutes with hood/lid down. . Cool. 3. Prepare for use. . Optional step: Line drip tray with heavy-duty aluminum foil and a thin layer of sand or bird gravel. . Protect the finish with a stainless steel cleaner or protective polish. See care suggestions Page 23. Page 11 SECTION 3: USING YOUR CHAR GLO® BARBECUE LIGHTING INSTRUCTIONS WITH AUTOMATIC IGNITION – Read Before Lighting – Main and Smoker Burners: Infrared Rotisserie Burner: 1. Raise hood/lid. 1. Raise hood/lid. 2. Light only one burner at a time. 2. IMPORTANT NOTE: Make sure the control knob is set to the “LITE” position when lighting 3. Always turn control knob to the “Lite” position and the infrared burner. Confirm that the burner immediately press and hold the ignition switch. The has lit within 30 - 45 seconds. The flame will be burner will light within 4 -10 seconds. blue initially. 4. Release ignition switch after burner ignites. Look 3. Allow the burner to operate on "HI" until it for the flame to check that it is lit. For the smoker burner, pull drawer open to see the flame. begins to glow orange/red (typically 2-3 minutes) before adjusting the control knob to the desired 5. Repeat procedures until desired number of burners flame setting. are lit. 3. Adjust control knob to the suggested flame 6. Adjust control knobs to the suggested preheat setting. Refer to the Rotisserie Cooking Chart flame setting. Refer to the Grill Cooking Chart Page 20. Pages 16 and 17. Side Burner/s: 1. Remove stainless steel cover; set aside. 2. Turn control knob to the “Lite” and immediately press ignition switch. The burner will light within 4 -10 seconds. 3. Adjust control knob to the desired flame setting. Page 12 SECTION 3: USING YOUR CHAR GLO® BARBECUE MANUAL LIGHTING INSTRUCTIONS** – Read Before Lighting – Follow these steps to light the Main Burners manually: 1. Turn off all the burners. 2. Wait 5 minutes to allow any accumulated gas to dissipate. Middle section of radiant Access Hole for Manual Lighting Use a long stem match to light manually: 3. Remove the grill grates. 4. Find the ports on top of the burner by looking through the opening at the end of the radiant. Keep your hands and face as far away from the burner as possible. 5. Place the lighted long-stem match through the hole in the radiant (see illustration above). This position is near the burner ports. 6. Turn the knob to the LITE position. The burner will light within 4 to 10 seconds. Follow these steps to light the Smoker manually: 1. Turn off all the burners. 2. Wait 5 minutes to allow any accumulated gas to dissipate. 3. Remove the smoker tray. 4. Find the ports on top of the smoker. Keep your hands and face as far away from the burner as possible. 5. Place the lighted match through the opening for the smoker tray and next to the burner ports. 6. Turn the knob to the LITE position. The burner will light within 4 to 10 seconds. ** NOTE: The infrared rotisserie burner cannot be l...

Download now

Please, enter two numbers from picture: