For watercooling system with 1/2” or 10mm ID tubes
1. Insert a fitting (1/2” to 3/8” ID or 10mm to 3/8” ID) into the tube.
Your watercooling system may come with tube clips. Use the clips to fasten the
fittings and the tubes together.
2. Connect a supplied 3/8” ID tube to the fitting.
3. Firmly press a tube clip and hitch it to the bottom end of the 3/8” ID tube.
4. Press another clip and hitch it to the top end of the 3/8” ID tube.
1
2
3
4
5. Press the clip and connect the assembled tube to the waterblock. When
done, release the clip to tighten the two together.
6. Repeat Step to 5 for another tube. Make sure that both tubes are well
connected to prevent leak, and then fill the coolant into the reservoir. The
picture shows a watercooling system installed to the motherboard.
5
6
2
Installing Fusion Block System accessory

---

...

Other models in this manual:
Motherboards - Blitz Formula (837.42 kb)
Motherboards - Blitz Formula (Special Edition) (837.42 kb)