Login:
Sorted: Name ↑   Downloads   Rate   Size ↑  
downloaded: 2   File size: 2 mb   Manafacture: Grizzly  
Category: Hair Clippers
@name

downloaded: 5   File size: 2 mb   Manafacture: Grizzly  
Category: Hair Clippers
@name

downloaded: 3   File size: 444 kb   Manafacture: Grizzly  
Category: Hair Clippers
@name

To protect your hands, always wear leather hand protection when operating this shear. Figure 1. Setting gap with shims. Test Run Your Model H2867 has a slide style ON/OFF switch as shown in Figure 2. Before performing any cutting operations, turn the shear ON and listen for any unusual noises. If everything appears to be in working order, you are ready to begin cutting. Adjustments Your Model H2867 includes a set of three thickness shims: 0.005", 0.008" and 0.013". These shims are used to set th

downloaded: 0   File size: 2 mb   Manafacture: Grizzly  
Category: Hair Clippers
@name

downloaded: 1   File size: 89 kb   Manafacture: Grizzly  
Category: Hair Clippers
@name

Check for alignment of moving parts, binding of moving parts, breakage of parts, mounting, and any other conditions that may affect its operation. A guard or other part that is damaged should be properly repaired or replaced. 19. NEVER LEAVE TOOL RUNNING UNATTENDED. TURN POWER OFF. Don’t leave tool until it comes to a complete stop. -2- H0600 12V Cordless Trimmer CHARGING SAFETY 1. READ ALL INSTRUCTIONS and warnings on the battery and charger before charging the battery. 2. CHARGE ONLY USING THE

downloaded: 0   File size: 714 kb   Manafacture: Grizzly  
Category: Hair Clippers
@name

Loosen the middle and rear setscrews (shown with arrows in Figure 2) on the side of the shear- head. Figure 2. Loosening set screw. 2. Rotate the head until the desired position is reached, then tighten the setscrews. H5503 14 Gauge Swivel Head Shears Cutting To start a cutting operation: 1. Choose a work space that is adequate for the size of material to be cut and secure the workpiece. 2. Layout the cut lines in your material with a scribe or writing utensil. 3. Start cutting at the edge of th





Category