Votes - 0, Average rating: 0 ( )

Manafacture: Philips File size: 3.34 mb File name: Language of manual:

Corded clipping QC5050 only: Do not run the appliance from the mains when the battery is fully charged. To use the hair clipper connected to the mains: switch the hair , clipper off, connect it to the mains and wait a few seconds before switching it on. QC5010 only: 1 Insert the appliance plug into the appliance. (Fig. ) Insert the adapter into the wall socket. Using the appliance Clipping with comb attachment The hair length after cutting is indicated in millimetres on the , display.The settings correspond to the remaining hair length after cutting. The hair length after cutting is only visible when the comb is , attached. 1 Slide the comb attachment into the guiding grooves of the appliance (‘click’). (Fig. 5) Make sure that the arms of the comb attachment have been properly slid into the grooves on both sides. Set the comb to the desired hair length ( , 6, 9, 1 , 15, 18 or 1 millimetres) by turning the length lock (Fig. 6). Switch the appliance on (Fig. ). English Tips -We advise you to star t clipping at the highest setting and to reduce the hair length in small steps until you reach the desired hair length. -If a lot of hair has accumulated in the comb, remove the comb attachment and blow and/or shake the hair from the comb. Removing the comb does not change the selected hair length setting. -Write down the hair length settings used to create a cer tain hairstyle as a reminder for future clipping sessions. Clipping without comb attachment: You can use the clipper without comb attachment to contour the neckline and the area around the ears. Remove the comb attachment by pulling it off the appliance (Fig. 8). , Never pull at the flexible top of the comb attachment. Always pull at the bottom par t. The comb attachment keeps the cutting unit at a certain distance , from your head.This means that, if you use the clipper without the comb attachment, your hair will be cut off very close to the skin. Cleaning Clean the appliance ever y time you have used it. Do not use abrasives, scourers or liquids such as alcohol, petrol or acetone to clean the appliance. The appliance and the adapter may only be cleaned with the brush supplied. 1 Make sure the appliance is switched off and disconnected from the mains when you start cleaning it. Remove the comb attachment by pulling it off the appliance (Fig. 8). Push the middle part of the cutting unit upwards with your thumb until it opens and then pull it off the appliance (Fig. 9). Be careful that the cutting unit does not fall to the floor. Clean the cutting unit with the brush supplied (Fig. 10). 10 English 5 Also clean the inside of the appliance with the brush supplied (Fig. 11). 6 Place the lug of the cutting unit into the slot and push the unit back onto the appliance (‘click’) (Fig. 1 ). This appliance does not need any lubrication. replacement A worn or damaged cutting unit should only be replaced with an original Philips cutting unit. Push the middle part of the cutting unit upwards with your thumb , ...

Download now

Please, enter two numbers from picture: