Votes - 3, Average rating: 4 ( )

Manafacture: Black & Decker File size: 306.68 kb File name: Language of manual:

Do not operate with a broken hub or spool. • DAMAGE TO CORD – Keep power cord away from rotating line. If you damage the cord, unplug it from the power supply before moving the tool or examining the damage. A damaged cord must be replaced before further use. • DISCONNECT TOOL – When not in use, when replacing line, or prior to cleaning. • AVOID DANGEROUS ENVIRONMENTAL CONDITIONS – Do not use electric tools in damp or wet locations. Follow all instructions in this Instruction Manual for proper operation of your tool. Don’t use the tool in the rain. • DO NOT OPERATE portable electric tools in gaseous or explosive atmospheres. Motors in these tools normally spark, and the sparks might ignite fumes. • STORE IDLE TOOLS INDOORS – When not in use, tools should be stored indoors in a dry, locked-up place out of reach of children. • GROUND FAULT CIRCUIT INTERRUPTER (GFCI) protection should be provided on the circuits or outlets to be used for the gardening appliance. Receptacles are available having built in GFCI protection and may be used for this measure of protection. • SECURE EXTENSION CORD using the cord retainer shown in Figures 4 and 5. • STAY ALERT – Watch what you are doing. Use common sense. Do not operate tool when you are tired. • MAINTAIN APPLIANCES WITH CARE – Follow instructions for lubricating and changing accessories. Inspect extension cords periodically and replace if damaged. Keep handles dry, clean and free from oil and grease. • CHECK DAMAGED PARTS – Before further use of the appliance, a guard or other part that is damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment of moving parts, binding of moving parts, breakage of parts, mounting, and any other condition that may affect its operation. A guard or other part that is damaged should be properly repaired or replaced by an authorized service center unless otherwise indicated elsewhere in this manual. • WARNING: When servicing double insulated tools, USE ONLY IDENTICAL REPLACEMENT PARTS. Replace or repair damaged cords. • WARNING: To prevent electrical shock hazard, use only with an extension cord suitable for outdoor use. Always connect extension cords to a fused line or one protected by a circuit breaker. To reduce the risk of electric shock, this equipment has a polarized plug (one blade is wider than the other) and will require the use of a polarized extension cord. The appliance plug will fit into a polarized extension cord only one way. If the plug does not fit fully into the extension cord, reverse the plug. If the plug still does not fit, obtain a correct polarized extension cord. A polarized extension cord will require the use of a polarized wall outlet. This plug will fit into the polarized wall outlet only one way. If the plug does not fit fully into the wall outlet, reverse the plug. If the plug still does not fit, contact a qualified electrician to install the proper wall outlet. Do not change the equipment plug, extension cord receptacle, or extension cord plug in any way. Make sure your extension cord is in good condition. When using an extension cord, be sure to use one heavy enough to carry the current your product will draw. An undersized cord will cause a drop in line voltage resulting in loss of power and overheating. The table shows the correct size to use depending on cord length and nameplate ampere rating. If in doubt, use the next heavier gauge. The smaller the gauge number, the heavier the cord. If the extension will be used outside, the cord must be suitable for outdoor work. The letters “WA” on the cord jacket indicate that the cord is suitable for outdoor use. SAFETY WARNINGS AND INSTRUCTIONS: POLARIZED PLUGS SAFETY WARNINGS AND INSTRUCTIONS: EXTENSION CORDS Minimum Gauge for Cord Sets Volts Total Length of Cord in Feet 120V 0-25 26-50 51-100 101-150 240V 0-50 51-100 101-200 201-300 Ampere Rating More Not more American Wire Gauge Than Than 0 - 6 18 16 16 14 6 - 10 18 16 14 12 10 - 12 16 16 14 12 12 - 16 14 12 Not Recommended SAVE THESE INSTRUCTIONS Figure 1 Figure 2 Raised Lug Borne Ceja Rotate 90. Faire pivoter sur 90. Gire 90. Figure 3 Figure 4 Figure 5 Cut-off Blade Lame de coupe Cuchilla de corte 10 - 30 0 0 Figure 6 Figure 7 Figure 8 Figure 9 Figure 10 Push Button Bouton-poussoir Oprima el boton Push Button Bouton-poussoir Oprima el boton Extend Tube Tube de rallonge Extienda el tubo Height Adjustment is available only on Model GH500 Dispositif de reglage de la hauteur, modele GH500 El ajuste de altura solo esta disponible en los modelos GH500 Figure 11 Figure 12 Cutting Line Fil tranchant Linea de Corte Figure 14 Figure 13 Figure 15 Conversion Button Bouton de conversion Boton de conversion Air Intake Slots Fentes d’admission d’air Tomas de aire • WARNING: The guard must always be on the tool to protect the user. NEVER OPERATE TOOL WITHOUT GUARD FIRMLY IN PLACE. Unplug the tool before attempting to attach the guard. 1. Attach edge ...

Download now

Please, enter two numbers from picture: