Votes - 4, Average rating: 3.8 ( )

Manafacture: Husqvarna File size: 436.57 kb File name: d8cd6959-5b20-41ca-9aa2-f4ab1396bad9.pdf Language of manual:

(Picture 10) 5. Lock the gear shaft by putting a pin provided or screwdriver through the aligned keyholes in the gear case cover and the gear case. Use a socket wrench to tighten the blade-mounting bolt. Rotate bolt counter clockwise to tighten. (Picture 11) 6. Split the bracket, install the wheel assembly to the tube, and clamp it at the position best for your job, using two screws. (Picture 12 and 13) 7. You can replace loop handle with the U-shaped handle that comes with your Edge Trimmer Attachment. Pin Picture 11 1 2 5 34 3 2 1 4 5 Picture 1 Picture 2 Gear Case Blade Guard Picture 3 Picture 4 Screws Cover Shaft Clamp Picture 5 Picture 6 Gear Case Cover Blade Picture 7 Picture 8 Clamping Plate Picture 9 Bracket 4.0-4.5” Picture 12 Picture 13 Mounting Bolt Picture 10 Attaching the Edger to the Power Head assembly. No tools are required to attach the Edge Trimmer to the power head assembly. 1. Pull the spring pin up on the adapter of the power head shaft assembly. (Picture 14) 2. Carefully fit edger drive shaft into adapter, making sure that male spline of the inner drive shaft engages into the female spline socket of the power head shaft. 3. When the drive shaft is properly aligned, the spring pin will drop into the hole on the shaft of the edger attachment. A click should be heard when completed. 4. Insure two shaft parts are fully engaged by twisting them. 5. Full engagement will prevent shaft rotation. 6. Secure assembly by tightening the knob. (Picture 15) Balancing and Depth Adjustment Check the balance of the assembled unit. The handles and shoulder harness have been assembled at the factory and set according to the average sized person. This can be adjusted to the operator’s preference. 1. Unit handles can be re-adjusted to the operator’s preference by simply loosening the screws and sliding handles up or down the shaft. Re-tighten the screws (Picture 16). The distance between the replacement portion of the blade and the foremost portion of the guiding handle should be at least 18" (450mm). (Picture 17) 2. Wheel height can be re-adjusted by loosening clamp lever, and changing the height of the wheel to achieve desired cutting depth. (Picture 18) Up-deep cut, down-shallow cut. Picture 14 Picture 15 Picture 16 down up Picture 17 Picture 18 Replacement Blade Installation Tools: 9/16" wrench, pin or screwdriver 1. Lock the gear shaft by inserting the pin or screwdriver through the aligned keyholes in the gear case cover and the gear case to prevent rotation (Picture 19). 2. Hold the pin or screwdriver in place and remove bolt by turning it clockwise (Picture 20), then remove clamping Picture 19 Picture 20 plate (Picture 21), and worn blade (Picture 22). 3. Place new blade (Picture 23), re-install clamping plate (Picture 24), and bolt (Picture 25). Use wrench to tighten the blade-mounting bolt. If bolt is worn or damaged use a new one. Replace worn or damaged blade and bolts in sets to preserve balance. Picture 21 Picture 22 WARNING – DANGER BE SURE UNIT IS UNPLUGGED BEFORE MAKING ANY ADJUSTMENTS. Picture 23 Picture 24 Picture 25 Trimming Techniques Storage 1. Clean. 1. With both hands o...

Download now

Please, enter two numbers from picture: