Votes - 3, Average rating: 4
(
)
)
|
manual abstract
Keep the cord away from heat, oil and sharp edges. 11. Maintain tool with care. Keep cutting tools sharp and clean for better and safer performance. Follow instructions for lubrication and changing accessories. Inspect tool cord periodically and if damaged, have it repaired by an authorised service facility. Inspect extension cords periodically and replace, if damaged. Keep handles dry, clean and free from oil and grease. 12. Disconnect tools. When not in use, before servicing and when changing accessories such as blades, bits and cutters. 13. Remove adjusting keys and wrenches. Form the habit of checking to see that keys and adjusting wrenches are removed from the tool before turning it on. 14. Avoid unintentional starting. Do not carry a plugged in tool with a finger on the switch trigger. Ensure switch is off when plugging in. 15. Use outdoor extension leads. When tool is used outdoors, use only extension cords intended for outdoor use. 16. Important extension cord information: a. Make sure the extension cords are in good condition before use. b. Based on the total length of cord that you are going to use, check the chart to make sure the cord meets the correct minimum cord gauge (AWG) requirements. IMPORTANT NOTE: Using an undersized cord or a larger number cord gauge (AWG) than recommended in the chart, will cause a loss in power and overheating of the unit. Using a smaller number cord gauge (AWG) than recommended in the chart, is acceptable. Extension cord chart (minimum cord gauge (AWG)) Length (metres) .3 to 7.8 7.9 to 15.5 15.6 to 30.6 30.7 to 45.7 Cord gauge (AWG) 18 16 14 12 17. Stay alert. Watch what you are doing. Use common sense. Do not operate tool when you are tired, ill or under the influence of alcohol or other drugs. 18. Check damaged parts. Before further use of the tool, a guard or other part that is damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment of moving parts, free running of moving parts, breakage of parts, mounting and any other conditions that may affect its operation. A guard or other part that is damaged should be properly repaired or replaced by an authorised service centre unless otherwise indicated in this instruction manual. Have defective switches replaced by an authorised service facility. Do not use the tool if the switch does not turn it on and off. Don’t operate the machine with a damaged or excessively worn cutting device. WARNING – DANGER LITTLE WONDER WILL NOT BE RESPONSIBLE FOR THE FAILURE OF CUTTING DEVICES OR ACCESSORIES THAT HAVE NOT BEEN TESTED AND APPROVED FOR USE WITH THIS UNIT. USE ONLY MANUFACTURER-RECOMMENDED REPLACEMENT PARTS. 19. The use of any accessory or attachment, other than those recommended in this instruction manual, may present a risk of personal injury. 20. Have your tool repaired by a qualified person. This electric tool conforms to relevant safety requirements. Repairs should only be carried out by qualified persons using original spare parts, otherwise this may result in considerable danger to the user. 21. Keep in mind that the operator or user is responsible for accidents or hazards occurring to other people or their property. 22. Work only in daylight or in good artificial light. 23. Keep all guards attached at all t...
Other models in this manual:Hair Clippers - Hedge Trimmer E System (2.42 mb)
Hair Clippers - Hedge Trimmer E System (2.42 mb)
Hair Clippers - Hedge Trimmer E System (2.42 mb)
Hair Clippers - Hedge Trimmer E System (2.42 mb)