Votes - 6, Average rating: 4.5
(
)
)
|
manual abstract
To record over this side again, cover the tabs with a piece of adhesive tape. Recording from the radio 1. Tune to the desired radio station (See TUNING TO RADIOSTATIONS). 2. Press STOP/EJECT (a±) to open the cassette door. 3. Insert a suitable cassette into the cassette deck and close the cassette door. 4. Press RECORD (•) to start recording. 5. For brief interruptions, press PAUSE. To resume recording, press PAUSE again. 6. To stop recording, press STOP/EJECT (a4). MAINTENANCE Tape deck maintenance To ensure quality recording and playback of the tape deck, clean parts A ,B and C shown in the diagram below, after approx. 50 hours of operation, or on average once a month. Use a cotton bud slightly moistened with alcohol or a special head cleaning fluid to clean the deck. 1. Open the cassette door by pressing STOP/EJECT (aA). 2. Press PLAY and clean the rubber pressure rollers C . 3. Press PAUSE and clean the magnetic heads A and also the Capstan B. 4. After cleaning, press STOP/EJECT (a±). Note: Cleaning of the heads can also be done by playing a cleaning cassette through once. -Q- 34 6 9.qxd 13.05.05 11:58 Page 6 ENGLISH CD Player Playing a CD This CD-player can play Audio Discs,MP3, CD-R. Do not try to play CD-Rewritables,CD-ROM, CDi.VCD.DVD or computer CD. 1. Adjust the source selector to MP3/CD. Display: shows -CLS- Briefly. 2. To open the CD door, press CD OPEN button. 3. Insert a CD or CD-R with the printed side facing up and press on CD Door CLOSE PUSH gently to close. Press (411) on the set to start playback. 4. To pause playback press (411). TO resume, press (411) again. 5. To stop CD playback, press STOP (■). Note: CD play will also stop when: - you open the CD compartment; - you select RADIO sound source; - the CD has reached to the end. Selecting a different track During playback you can use (9) or (:) to select a particular track. • If you have selected a track number in the stop or pause position, press ( Hi) to start playback. • Press (:) once briefly for the next track, or press repeatedly until the desired track number appears in the display. • Press (9) once briefly to return to the beginning of a current track. • Press (9) more than once briefly for a previous track. Finding a passage within a track 1. Press and hold down (9) or (:) . • The CD is played at high speed and low volume. 2. When you recognize the passage you want release (9) or (:). Normal playback resumes. Different play modes: Repeat repeat - plays the current track continuously. repeat all - plays the entire CD continuously. Programming track numbers You may store up to 20 tracks in the desired sequence. If you like, store any track more than once. 1. In the STOP mode, press (9) or (:) for your desired track. 2. When your chosen track number appears, press PROG MODE once to store the track. The display shows prog and prog briefly followed by your selected track number. 3. Repeat steps 1 to 2 to select and store all desired tracks in this way. 4. To play your program, press ( Hi) Reviewing your set program • In the STOP mode, press PROG MODE. The display shows your stored track numbers in sequence. Erasing a program You can erase the contents of the memory by: - opening the CD door; - selecting RADIO source; - pressing ■ (twice during playback or in the stop Position) MAINTENANCE & SAFETY Precautions & General Maintenance • Place the set on a hard and flat surface so that the system does not tilt. • Do not expose the set, batteries or CDs to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight. • Do not cover the set. Adequate ventilation with a minimum gap of 6 inches between the ventilation holes and surrounding surfaces is necessary to prevent heat build-up. • The mechanical parts of the set contain self-lubricating bearings and must not be oiled or lubricated. • To clean the set, use a soft dry cloth. Do not use any cleaning agents containing alcohol, ammonia, benzene or abrasives as these may harm the housing. CD player and CD handling • The lens of the CD player should never be touched! • Sudden changes in the surrounding temperature can cause condensation to form and the lens of your CD player to cloud over. Playing a CD is then not possible. Do not attempt to clean the lens but leave the set in a warm environment until the moisture evaporates. • Always close the CD door to keep the CD compartment dust-free. To clean, dust the compartment with a soft dry cloth. 6 -Q- 34 6 9.qxd 13.05.05 11:58 Page 7 ENGLISH • To clean the CD, wipe in a straight line from the centre towards the edge using a soft, lint-free cloth. Do not use cleaning agents as they may damage the disc. • Never write on a CD or attach any stickers to it. Troubleshooting If a fault occurs, first check the points listed below before taking the set for repair. Do not open the set as there is a risk of electric shock. If you are unable to remedy a pro...