Votes - 2, Average rating: 4.5
(
)
)
|
manual abstract
To insure trouble free long term performance from your new unit, please take a moment to read this manual completely to make yourself aware of all basic radio operation and memory setting procedures. Also at this time, it would be a good idea to write down the serial number of the unit in the space provided. In the unlikely event that the radio will need warranty service, you will need this number to obtain the service. Serial # ________________________ Mechanical Installation Space Requirements: To mount your new AM/FM cassette unit, you will need a rectangle hole in the mounting location 182mm (width) x 53mm (height), (7.8” x 2 1.8”) and a full 6” of unobstructed space behind the mounting location. Step 1: After obtaining the required space and mounting hole dimensions required, remove the mounting sleeve from the unit. Insert the mounting sleeve into the hole on the dashboard. Secure it by bending the tabs inward as shown in fig 1. Select the appropriate tab according to the thickness of the dashboard. Step 2: Bring the power, ground, antenna and speaker wires through the center of the mounting sleeve. Make all the speaker and power connections to the main harness supplied with the unit. Refer to the “wiring” section of this unit for proper connection. After all the connections have been made and are correct, plug the harness and the antenna cable into the mating plugs located on the rear of the unit. Step 3: Turn on the ignition key and do a pre-installation check of all the functions with the unit out of the dashboard to make sure that everything is operating properly before final installation. Step 4: Securely attach the rear support strap provided to the rear of the unit with the fasteners provided. Bend the strap to allow the unit to slide into it’s mounting sleeve. Reach up behind the unit and grab the strap while sliding the unit into the mounting sleeve until it snaps into place. Secure the end of the strap to a solid portion of the dashboard structure or the fire wall. Installation Procedure Removing the Unit: In the event that the unit requires removal from it’s mounting location, repeat the following procedures. A. Release the rear support strap. B. Insert the keys provided into the slot on both sides of the chassis until locked. (snapped into place) C. Pull on the keys with equal pressure to release and remove the unit from the mounting sleeve. D. Disconnect the wire harness and the antenna. Wiring: Note 1: If you are installing a completely new system, install all of the speakers and antenna first, then run the wires up to the radio mounting location and bring them through the radio mounting hole. Note 2: Your new AM/ FM cassette unit has been designed to operate properly when connected to a “12 Volt Negative Ground” electrical system. Any other power supply may not be acceptable. Connecting your new unit to other than the specified power source will damage the unit and will void the warranty. If you are not sure that your vehicle uses a “12 Volt Negative Ground” electrical system, contact your local car stereo installation center and find out before making any connections. Red Wire: Connect the red wire to a source of 12 volts that is controlled by the ignition key. Use a test light or volt meter to locate a connection point at the fuse block. Black Wire: Connect the black wire to the frame of the vehicle. It is strongly recommended that the black wire be connected to a part of the vehicles frame, floorboard or sub structure to insure a good ground. It is Not advisable to connect the black wire to a factory provided ground wire. It is possible that many other electrical items will be connected to this wire and electrical no...
Other models in this manual:Audio Players - M9850 (424.77 kb)
Audio Players - M9850 (424.77 kb)
Audio Players - M9860f (424.77 kb)
Audio Players - M9860f (424.77 kb)