Votes - 2, Average rating: 4.5 ( )

Manafacture: Yamaha File size: 223.01 kb File name: KX-380Kai.pdf Language of manual:

.Recording Mute function .Fine Adjustment of Recording Characteristics with Auto Tape Tuning and Bias Adjust Control .160 kHz High Recording Bias prevents cross modulation beat distortion that can occur between the recording bias and the recording signal’s high frequency content (KX-580 and KX-480 only). CONNECTIONS LINE OUT PLAY LINE IN REC TAPE PBREC OUT L R L R To an AC outlet ... Amplifier or receiver REAR PANEL CONNECTIONS Make sure that power to both the deck and your amplifier/receiver are turned off before making any connections. The White plug on the paired connecting cables corresponds to the Left channel and the Red plug corresponds to the Right channel. Make sure that the left and right channel connections are properly made, and that the plugs are inserted firmly. The LINE OUT/PLAY jacks on the deck should be connected to the Tape PB (Playback/Input) jacks on your amplifier/ receiver, and the LINE IN/REC jacks on the deck should be connected to the Rec Out (Rec/Output) jacks on your amplifier/receiver. Connect the power cord to an AC wall outlet or to an AC outlet on the rear panel of your amplifier/receiver (if provided). PLAYBACK PLAYBACK Preparation for playback .Be sure to set the TIMER switch to the OFF position (KX-580 and KX-480 only), then turn on the POWER switch. .Set your amplifier or receiver to cassette deck function mode. KX-580/KX-480 PHONES LEVEL 1 3 ! . STOP MPX FILTER indicator YB/YC and YS (KX-580 only) indicators When a tape is loaded, the corresponding tape type indicator lights. TIMER POWER =ON PHONES PLAY TRIM 2 REC/PAUSE (KX-580 only)2 KX-380 MPX FILTER indicator When a tape is loaded, the 3 ! . STOP corresponding tape type indicator lights.POWER =ON YB/YC indicators PHONES PLAY TRIM PHONES LEVEL 2 REC/PAUSE 1 1 EJECT 2 KX-580 DOLBY NR OFF/YS/MPXOFF/YB/YC/MPX 3 PLAY Insert the cassette with the exposed tape side facing down and the side to be played facing you. To close the compartment, push in the compartment door until it locks shut. KX-480/KX-380 DOLBY NR OFF/YB/YC/MPX To stop playback: Press the STOP button. To fast forward the tape: Press the .button. To fast rewind the tape: Press the !button. To adjust the volume level: Use the volume control of the amplifier or receiver. To use headphones for private listening: Insert the headphones plug into the PHONES jack. To adjust the headphones level: Use the PHONES LEVEL control. DOLBY S NR DOLBY S NR is developed incorporating the concept of professional-use DOLBY SR system into the present DOLBY B/C NR. It offers the noise reduction effect increased by about 40%, compared to the former DOLBY C NR, and also the noise level of the low frequency range is reduced to 1/3. Highly natural sound can be reproduced with the help of the modulation controller, which regulates 5 NR units — 2 for low level sounds and 3 for high level, one of which is for low frequency signals. DOLBY S NR has also high interchangeability. The tapes recorded with DOLBY S NR can well be reproduced by the decks which are equipped only with DOLBY B NR, headphone stereos or car stereos for example. DOLBY NR button setting (in step 2) DOLBY NR (OFF/YB/YC/MPX) button Be sure to set the DOLBY NR (OFF/YB/YC/MPX) button according to the system used for recording. Each time this button is pressed, Dolby NR switches as follows: 3 YB(MPX off) For a tape recorded with DOLBY B NR Only the YB indicator lights. . YC(MPX off) For a tape recorded with DOLBY C NR Only the YC indicator lights. . YB MPX on (available only for recording) . YC MPX on (available only for recording) . OFF For a tape recorded with DOLBY NR OFF No indicator lights. KX-580 only DOLBY NR (OFF/YS/MPX) button For a tape recorded with DOLBY S NR, use this button to select the appropriate setting. Each time this button is pressed, DOLBY NR switches as follows: 3 YS(MPX off) For a tape recorded with DOLBY S NR Only the YS indicator lights. . YS MPX on (available only for recording) . OFF For a tape recorded with DOLBY NR OFF No indicator lights. * Dolby noise reduction manufactured under license from Dolby Laboratories Licensing Corporation. “DOLBY” and the double-D symbol Yare trademarks of Dolby Laboratories Licensing Corporation. Note: The MPX filter settings are explained on page 10. Noise Reduction Responce NR-OFF S-NR C-NR B-NR 10 dB 20 100 1k 10k 20k Hz PLAY TRIM control adjustment When the level of high frequencies is too boosted or absent while playing a tape recorded on another cassette deck, adjust the high frequency response with the PLAY TRIM control. When high frequencies are When high frequencies are too boosted, attenuate the absent, boost the high high frequencies. frequencies. PLAY TRIM PLAY TRIM 0 0 –+ –+ 1 + 2 10 dB _ 3 100 1k 10kHz 1 High frequency sound is too boosted. 2 Flat. 3 High frequency sound is absent. MUTE/SEARCH INTRO indicator INTRO SCAN @ PLAY INTRO SCAN # . ! SELECTION SEARCH - To play back a desired selection by searching for the beginning of the selection To search fo...

Download now

Please, enter two numbers from picture: