Votes - 3, Average rating: 3.7
(
)
)
|
manual abstract
• Avoid using or storing this unit in dusty or sandy locations. LOCATION OF CONTROLS 1 11 12 2 13 8 3 14 9 4 15 10 6 75 1. Carrying Handle 9. SET Button 2. RECORD Indicator 10. Display 3. VOICE RECORD Button 11. Built-in Microphone 4. MODE Button 12. Belt Clip 5. PLAY Button 13. Earbud Jack 6. STOP Button 14. VOLUME Control 7. FAST FORWARD Button 15. Battery Compartment (Rear of 8. VOICE PLAY Button Unit) 1 HK39.IT.QXD 8/22/02 4:51 PM Page 3 POWER SOURCE BATTERY OPERATION 1. Remove the belt clip. Open the battery compartment by pushing the tab at the center of the cover and lift it up. The door cannot be removed, so it cannot be lost. +- -+ -+ For Clock 2. Insert three (3) AA size batteries (not included) into the For Cassette Player Battery Compartment following the diagram inside the compartment and replace the Battery Compartment cover. BATTERY PRECAUTIONS Follow these precautions when using batteries in this device: 1. Use only the size and type of batteries specified. 2. Be sure to follow the correct polarity when installing the batteries as indicated next to the battery compartment. Reversed batteries may cause damage to the device. 3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh ones. 4. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage. 5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery manufacturer’s directions.) OPERATION FCC INFORMATION: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) This device may not cause harmful interference, and 2) This device must accept any interference received, including interference that may cause undesired operation. TO CYCLE THROUGH THE CLOCK MODES: Press the MODE button once to view the alarm time, twice to view the date and a third time to view the second’s display. Press once more to revert back to the present time. SETTING THE DATE AND TIME 12 1 12 2 3 Press the SET button . four times; the month will appear. Press the MODE button . repeatedly to set the present month. Repeat this step to set the date. Press the SET button . again and the present hour will appear. Press the MODE button . repeatedly to set the present hour and AM/ PM. Repeat this step to set the minute. Press the SET button and the clock will be set and running. 2 HK39.IT.QXD 8/22/02 4:51 PM Page 4 OPERATION (CONTINUED) SETTING THE ALARM TIME 12 1 12 2 3 Press the SET button . once; the alarm time will blink. Press the SET button .; the alarm hour and AM/PM will blink. Press the MODE button . repeatedly to set the alarm hour and AM/ PM. Press the SET button . again and the alarm minute will blink. Press the MODE button . repeatedly to set the alarm minute. Press the SET button to return to the present time display. ACTIVATING THE ALARM Press the SET button . once; the alarm time will blink. Press the MODE button . once to turn the alarm on, the Alarm indicator ( ) will appear in the display. 12 1 When the actual time matches the alarm time, the unit will beep for 30 seconds. To turn the alarm off, press the MODE button. 3 Press the MODE button again to turn the alarm and chime (see below) on; the Alarm ( ) and Chime ( ) indicators will appear in the display. Press the MODE button once again to turn the Chime off. Repeat the same to turn the Alarm off. 2 TURNING THE CHIME ON: When the Chime is activated, a beep will sound every hour. 3 Press the SET button . once; the alarm time will blink. Press the MODE button . twice to turn the alarm (see above) and chime on; the Alarm ( ) and Chime ( ) indicators will appear in the display. 12 1 Press the MODE button once again to turn the Chime off. 3 Press the MODE button again to turn the chime on, the Chime indicator ( ) will appear in the display. 2 HK39.IT.QXD 8/22/02 4:51 PM Page 5 OPERATION (CONTINUED) USING THE CASSETTE PLAYER Open the cassette door by lifting the opening tab on the right of the door and insert a cassette tape with the open surface facing up. Close the Cassette Door and plug the earbuds into the Earbud jack. 1 To stop the tape before it reaches the end, press the Stop button .. Press the Fast Forward button . to fast forward the cassette. 213 Set the VOLUME control . to minimum and press the PLAY button . to begin playback. Adjust the VOLUME control . as desired. 1 2 2 USING THE 10 SECOND VOICE RECORDER To record up to 10 seconds of voice recording, press and hold the RECORD button; the RECORD indicator will light. 1 Press the VOICE PLAY button to listen to the digital recording through the earbuds. 3 Speak into the built-in microphone. When done recording, release the RECORD button; the RECORD indicator will go out. 2 4 HK39.IT.QXD 8/22/02 4:51 PM Page 6 LIMITED WARRANTY Emerson Radio Corp. warrants manufacturing defects in original material, including original p...