Votes - 2, Average rating: 4
(
)
)
|
manual abstract
It does not relieve you from the responsibility for safe operation of your vessel. You must avoid hazards to navigation and never leave the helm unattended. In case of autopilot pump failure or leakage, shut the valves located on the front of the manifold see page 15. NOTE: Before proceeding with the installation, read these instructions thoroughly. TR-1 Autopilots cannot accept responsibility for installations where instructions have not been followed, where substitute parts have been used, or where modifications have been made to our products. Contents Safety................................................................ 1 Parts List........................................................... 3 Hydraulic Layout (SeaStar Power Assist) ....... 4 Hydraulic Layout (Single Helm)...................... 5 Hydraulic Layout (Dual Helm)........................ 6 Electrical Layout.............................................. 7 Wireless Remote Wireless Parts List 44-45 Introduction 46 Remote Functions, Two Button 47 Remote Functions, Five Button 48 Installation 49 Installation Considerations 49 Installation of Wireless 49 Antenna Installation 49 Security Codes 50 Replacement Keypad 50 Changing Batteries 50 Chapter I: Section I Gladiator Installation Installation Check List 9 Gladiator Specifications 10 Preparation for Installation 10 - 12 Mounting Considerations 12 Component Protection 12 Hydraulic Connections 12 Magnetic Environment 12 System Maintenance 12 Unbalanced Valve Installation 13 Pump Unit Installation 14-15 Compass Ball Installation 16-17 Electronic Control Unit (ECU) 18 NMEA 0183 Connections 19 Blue Connectors 19 Non-Compliant NMEA Devices 20 Shadow Drive Installation 21-22 Warning Horn Installation 23 Deckmount On/Off Installation 24 Handheld Installation 25 Tachometry Connections 26-27 Battery Connection 28 Bleeding Hydraulics 28 System Warranty................................51 Section II: Setup..........................................29 Dockside Setup 29 Sea Trial Setup 30 Compass Calibration 30 Autotune 31 Set North 32 Fine Tuning 33 Section III: Troubleshooting........................34 Section IV: How to change parameters of the setup codes....................35 Table of Setup Codes 36-38 GPS Connection Guide 39-42 Hydraulic Layout for SeaStar Power Assisted Helms P= PortR= ReturnS= StarboardPRSReturn line .......................................................................................................................................................................................................................................................................................................................................................................................... .......................................................................................................... **Shadow Drive1) MountHorizontally and as levelas possible2)May be located in the Port or Starboard Hydraulic Lines3) Use a length of hose between helm and Shadow Drive Valve4)DO NOTinstall Valve directly to helm! 5) Tee fitting MUST NOTbe installed between helm and Shadow Drive Valve6) Tee fitting that joins pump to the cylinder must go after Shadow Drive Valve and after the Power Assist Module. 7)DO NOT install the Shadow Drive in the Return or Compensating Line! ........................................ Pump & Motor ...................................................................................................................................................................................... BALANCED CYLINDERPort FittingStarboard Fitting .................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................... SeaStar Power AssistHydraulic Layout Hydraulic Layout Single Helm Single Helm Boats (Only) Hydraulic Layout*Shadow Drive1) MountHorizontally and as levelas possible2)May be located in the Port or Starboard Hydraulic Lines3) Use a length of hose between helm and Shadow Drive Valve4)DO NOTinstall Valve directly to helm! 5) Tee fitting MUST ...