Votes - 3, Average rating: 3.3
(
)
|
manual abstract
Slip the attached split ring through the small hole in the end of the rudder’s pivot bolt. (Illustration #1) 2. Attach the stern ends of the cables to the outer holes on the rudder. Place a stamped washer on each 1” bolt and drop them down through the holes on the rudder. Place a large flat washer then the cable loop then another large flat washer onto the bolt and secure with a locknut. (NOTE: Tighten the nut, being careful to leave enough room for the cable to move freely.)(Illustration #2) 3. Stretch the rudder raising cord forward along the topside of the deck; clip the hook end of the raising cord bungee to the raising cord, between the two knots. (Illustration #3) Illustration #3...
Other models in this manual:Boats Accessories - E1569 (759.53 kb)
Boats Accessories - E1574 (759.53 kb)
Boats Accessories - E3000 (759.53 kb)