Votes - 4, Average rating: 3.8
(
)
)
|
manual abstract
MAINTENANCE When not in use, store in Pole Light Storage Clips (Attwood #7571). Choose a storage location where light will not be damaged or be in constant contact with water. ATTWOOD LIMITED 10-YEAR WARRANTY Because of the longevity of Attwood’s LED lighting technology, Attwood offers a limited 10-year warranty on this LED lighting product. See Product Catalog or attwoodmarine.com for details. Pivot Screw Figure 5 One meter 7.5 or 39-3/8" Locking Collar Tab Threads CAUTION! Pinch Point Hinge Collar Hinge Hinge Collar Groove Tab Pole Screw • Locking Spring • Figure 3 2. Unfold pole so it is straight and threads are tight together. Slide hinge collar down and turn onto threads. Hand-tighten only. 3. To fold and stow, reverse steps 1 and 2. Insert tab of hinge collar into groove of locking collar. Press collars together. INSTALLATION Poles Without Locking Collar (5560 Series) 1. Align pole screw with the slot (or locking spring) in the existing base. Insert pole into base (Figure 3). #91020, #91024, • or #91026 Locking Collar • Lower Ring • Screw #91022 Locking Spring Locking Collar Locking Collar Lower Ring Screw • • • • • 2. Press down fi rmly to engage electrical connectors. With Easy Lock Base, be sure locking spring clicks over pole screw. 3. To remove: • Pull locking spring back (on Easy Lock Base) • Pull pole straight up. Poles With Locking Collar (5530 Series) 1. Align pole screw with the slot (or locking spring) in the existing base. Insert pole into base (Figure 4). Figure 4 Lights meet USCG CFR 183.810, ABYC A-16 requirements, and all applicable standards as tested by Imanna Laboratories, 5/3/2007. 2 nautical mile visibility. CAUTION Read all instructions carefully before installing and using this product. All positive (+12V DC) lighting wires require a 1-amp fuse to protect circuits and vessel. The aluminum light pole is not grounded. MAKE SURE POWER SOURCE IS 12-VOLT DC ONLY. HIGHER VOLTAGE WILL DAMAGE LIGHT AND CIRCUITRY. WARNING Disconnect power when installing or servicing this product. Remove boat from water before using any 120V AC power tools. LOCATION 5530 and 5540 Series All-Round Lights are designed for boats up to 39.4 feet (12m). Position the all-round light so its LED light source is not less than one meter (39.4") above sidelights. If replacing an existing pole light, replace with a pole at least as long as the existing pole. Mount the all-round light in a position so that: (Figure 1) • Light output is fl at and parallel to water when boat is fl oating. • Light shines 360°, unobstructed. • Light does not shine on operator, or refl ect off any part of the boat in the operator’s fi eld of vision. Vis du mat • Ressort de verrouillage • 3® Conforme aux exigences USCG CFR 183.810, ABYC A-16 et a toutes les normes applicables selon les tests d’Imanna Laboratories effectues le 5/3/2007. Visibilite de deux milles marins. MISE EN GARDE : Lisez toutes les directives attentivement avant d’installer et d’utiliser ce produit. Tous les ...
Other models in this manual:Boats Accessories - 5540 Series (194.26 kb)