July 1998 12" MITER SAW 3912 INDUSTRIAL Model 0601474039 Open for Tool Illustration Pos. Part Number Description {Qty} F/C Pos. Part Number Description {Qty} F/C 1 2 610 967 440 Motor Housing 71 S2 2 610 910 768 Bushing 82 2 2 610 911 47S Field 120V 22 S3 2 610 910 76S Spring 27 3 2 610 911 476 Armature w/Fan 120V AW S4 2 610 910 838 Lock Lever 64 4 2 610 910 020 Switch On/Off 120 V 1S SS 2 61S 297 329 Washer 6S 4/10 2 610 3S8 901 Screw {6} 89 S6 2 610 910 848 Nut 89 S 2 610 911 463 C

Part Number Description {Qty} F/C 4 1 903 201 042 Needle {2} 66 79 2 601 099 013 Cover 9 5 2 600 108 077 Felt Seal 77 80 2 601 099 029 Plastic Base 88 6 2 600 500 002 Washer 65 81 2 910 001 116 Screw {6} 89 7 2 600 905 021 Ball Bearing 61 82 2 601 320 022 Cover 92 8 2 916 669 008 Retaining Ring 89 85 2 604 610 040 Spring 27 9 2 600 400 008 Bushing 82 102 2 610 909 245 Field 120V 22 12 2 600 101 616 Washer 65 103 2 610 909 242 Armature w/Fan 120V AW 13 2 600 913 036 Needle Cage {2} 56 103/6 2 610

such as pipes, radiators, ranges and Do not overreach. Keep proper footing and refrigerators. There is an increased risk of balance at all times. Proper footing and electric shock if your body is grounded. If balance enables better control of the tool in operating the power tool in damp locations is unexpected situations. unavoidable, a Ground Fault Circuit Interrupter Use safety equipment. Always wear eye must be used to supply the power to your tool. protection. Dust mask, non-skid safety Elec

Removing the blade is essentially the reverse of the installation procedure, however, take note that once the blade change button is loosened, gently push the blade upward to release the blade tabs from the plunger. Operating Instructions SLIDE "ON-OFF" SWITCH The Tool is switched "ON" by the slide switch located at the side of the motor housing. TO TURN TOOL "ON": slide the switch forward. TO TURN TOOL "OFF": slide the switch backward. VARIABLE SPEED DIAL This tool is equipped with a Variable S

BM 2610993482 2-04 2/9/04 9:17 AM Page 8 The following types of blades should only be 2. Blades with teeth that point straight out used with orbital Setting O: rather than up or down. 1. Blades with teeth that point downward 3. Carbide-tipped blades. (reverse-tooth blades). 4. Grit-edge blades. FOOTPLATE ANGLE ADJUSTMENT The footplate may be tilted to allow angle cuts up to 45° in either direction. To adjust footplate, loosen screw (A) with allen wrench, slide the footplate towards the front of