3 HP Voltage...............................................................................................................................................................................220V Phase................................................................................................................................................................................Single Amps.................................................................................................................

PAGE 1 2 Modei ouooe Due to our ongoing improvement efforts, this information may not accurately describe items previously purchased. p«GE i ur 2 Blade Information Standard Blade Length.............................................................................................................................181 in. Blade Length Range.................................................................................................................180 - 181-1/2 in. Blade Width Range...........

684 lbs. Length/Width/Height............................................................................................................................. 40 x 31 x 87 in. Electrical: Switch.......................................................................................................Magnetic with Thermal Overload Protection Switch Voltage....................................................................................................................................................

PAGE 1 OF 2 Modei uuoio Due to our ongoing improvement efforts, this information may not accurately describe items previously purchased. p«GE i °r 2 Table Information Table Length..............................................................................................................................................17 in. Table Width................................................................................................................................................17 in. Table

paGc 2 OF 3 Modei Guo/o Due to our ongoing improvement efforts, this information may not accurately describe items previously purchased. r«Gc 2 °F 3 Other Specifications: ISO Factory...................................................................................................................................................ISO 9001 Country Of Origin..............................................................................................................................................

Flashing GREEN Constant Beeping (every 1/2 second) Low Battery Warning - The Back-UPS is supplying battery power to the load connected to the battery outlets, and the battery has 1.5 minutes of battery power remaining. Alternating GREEN & RED Constant tone Bad Battery Detected - Battery needs to be charged, or is at end of life and must be replaced (see Replace Battery). FlashingRED Constant tone Battery Disconnected - The battery is disconnected or it is a bad battery (see Replace Battery). Off

Off Short beep every 4 seconds Low Battery Shutdown - During On Battery operation the battery power was almost completely exhausted, and the Back-UPS is waiting for utility power to return to normal. Off Constant Tone On Battery Overload - Connected equipment requires more powerthan provided by Back-UPS battery. Unplug devices one at a time to remove overload. If not corrected contact APC Technical Support. GREEN On Constant Tone On Line Overload - The power drawn by the connected equipment exce

Fill water tank again and repeat basic operations previously outlined. yWARNINGy IMPROPER USE OF THE GROUNDED PLUG CAN RESULT IN THE RISK OF ELECTRICAL SHOCK. IF THE POWER CORD IS DAMAGED, HAVE IT REPLACED BY AN AUTHORIZED AVANTI PRODUCTS SERVICE CENTER. OPERATING YOUR WATER DISPENSER > Steps to replace water bottles • Use a clean cloth to wipe off neck of bottle. • Remove cap. • Carefully lift bottle (approx. 40 lbs.) using your legs and not your back. Do not place hands in opening of b

Volt 110V Frequency 60Hz H.P. 3.4 H.P. Amps 5.5 No load strokes 300-2000/min Max. cutting thickness wood 41.2" Stroke 13.16" Weight 71.4 lbs -4-H0799 Reciprocating Saw OPERATION Any time the saw is plugged into a power source, the reciprocating blade will activate when the trigger is depressed. Before making any adjustments or when changing blades, always remove the plug from the power source first. Failure to observe this will lead to serious personal injury. Inserting and Removing Saw Blades:

Don’t operate the machine with an air pressure lower than 6 Bar. 7.1. ADJUSTING THE AIR PRESSURE OF PNEUMATIC CLAMPS 7.1.1. Pull the adjustment button of the conditioner upwards. a-Turning the adjustment button in clockwise direction increases the pressure b-Turning the adjustment button in counter clockwise direction decreases the pressure c-Once you read 6-8 Bar (90-120 psi)on the manometer, push the adjustment button of the conditioner down and lock it in that position. 16 Operating and Safet