|
manual abstract
Minimum Gauge for Cord Sets Volts Total Length of Cord in Feet 120V 0-25 26-50 51-100 101-150 (0-7.6m) (7.6-15.2m) (15.2-30.4m) (30.4-45.7m) 240V 0-50 51-100 101-200 201-300 (0-15.2m) (15.2-30.4m) (30.4-60.9m) (60.9-91.4m) Ampere Rating More Not more American Wire Gauge Than Than 0 -6 18 16 16 14 6 -10 18 16 14 12 10 12 16 16 14 12 12 16 14 12 Not Recommended WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK: • Do not connect to AC distribution wiring. • Do not make any electrical connections or disconnections in areas designated as IGNITION PROTECTED. Thisincludes DC cigarette lighter type plug connection or airplane adapter. This unit is NOT approved for ignition protected areas. • NEVER immerse the unit in water or any other liquid, or use when wet. • Do not insert foreign objects into the AC outlet or the USB outlet. WARNING: TO REDUCE THE RISK OF FIRE: • Do not operate near flammable materials, fumes or gases. • DO NOT expose to extreme heat or flames. CAUTION: TO REDUCE THE RISK OF INJURY OR PROPERTY DAMAGE: • Remove appliance plug from outlet before working on the appliance. • DO NOT attempt to connect or set up the unit or its components while operating your vehicle. Not paying attention to the road may result in a serious accident. • Always use the inverter where there is adequate ventilation. Do not block ventilation slots. • ALWAYS turn the inverter OFF by disconnecting it from the DC accessory outlet when not in use. • Make sure the nominal powering voltage is 12 volts DC, center connection positive (+). • When using this unit in a vehicle, check the vehicle owner’s manual for maximum power rating and recommended output. Do not install in engine compartment — install in a well ventilated area. • Do not use with positive ground electrical systems.* Reverse polarity connection will result in a blown fuse andmay cause permanent damage to the inverter and will void warranty. *The majority of modern automobiles, RVs and trucks are negative ground. • Keep in mind that this inverter will not operate high wattage appliances or equipment that produce heat, such ashair dryers, microwave ovens and toasters. • Do not open the inverter — there are no user-serviceable parts inside. • Do not use this inverter with medical devices. It is not tested for medical applications. • Keep away from children.This is not a toy! • Install and operate unit only as described in this Instruction Manual. • Do not use this inverter on a watercraft. It is not qualified for marine applications. • Check unit periodically for wear and tear. Take to a qualified technician for replacement of worn or defective partsimmediately. • Read And Understand This Instruction Manual Before Using This Unit. SAVE THESE INSTRUCTIONS WARNING: TO REDUCE THE RISK OF INJURY: Follow these instructions and those published by battery manfacturer and the manufacturer of any equipment youintend to use with this unit. Review cautionary markings on these products and on engine. INTRODUCTION Thank you for purchasing the PI100AB/PI101B Power Inverter with USB Charging Port.This inverter can be used to operate personal electronics and mobile office equipment, such as: laptop computers, digital/video cameras, MP3 players, cell phones, PDAs, and more. It can also be used to recharge 110/120 volt AC devices that have anappropriate recharging adapter with a standard North American two- or three-prong plug. Please read this Instruction Manual carefully before use to ensure optimum performance and to avoid damage tothis product. INCOMPATIBLE PRODUCTS: CAUTION: Certain products contain power supplies or circuits that are not compatible with an inverter using a modified sine wave output (such as this inverter) and may be damaged by using this inverter. If your product requires pure sine wave AC input power to function properly, the instruction manual for your product could state this. If in doubt, you should contact your product manufacturer PRIOR TO USE. Some products must be powered from a pure sine wave power source, such as standard household power, or a “pure sine wave” inverter in order to function properly. Your product could be damaged by this inverter if it contains: 1. Transformer type power supplies 2. Microprocessor controlled power supplies 3. Capacitive coupled power supplies If an incompatible product is used with this inverter: • The product might not operate at all, with no indication of failure. The product fuse might have opened as a resultof trying to use it with the inverter. • The product exhibits unusual operation (such as, intermittent operation, buzzing, and the like.) WARNING: If the product does not operate normally, to reduce the risk of injury or property damage: • Turn the product off immediately and unplug it from the inverter. FEATURES • 100 watts continuous output* • MAXX SST® Soft Start Technology® • 5 volt DC USB Charging Port • Easiest inverter to use – truly plug and play • Bi-color Power/Fault LED Indicator • Compact, efficient and qu...
Other models in this manual:Saws - PI100AB (194.87 kb)