Votes - 3, Average rating: 3.7
(
)
)
|
manual abstract
Always stop tool operation and charge the battery cartridge when you notice less tool power 2. Never recharge a fully charged battery cartridge. Overcharging shortens the battery service life. 3. Charge the battery cartridge with room temperature at 10°C -40°C (50°F -104°F). Let a hot battery cartridge cool down before charging it. Hex wrench storage When not in use, the hex wrench can be Hex wrench conveniently stored. CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before e any adjustment is attempted. Adjusting depth of cut Loosen the lever on the depth guide and move the base up or down. At the desired depth of cut, secure the base by tightening the lever. CAUTION: Use a shallow depth of cut when cutting thin workpiece for cleaner, safer cuts. After adjusting the depth of cut, always tighten the lever securely. Sighting When cutting, align the left side of notch in the front of the base with your cutting line on the workpiece. Dust collection CAUTION: Never cut workpieces covered/stained with thinner, gasoline, oil or the like. If the dust box is stained with them, it may crack, causing an injury to operator. This tool is equipped with the dust box to Dust cap collect dust and cut chips. For the best cut- ting performance, empty the dust box each time the battery cartridge is completely dis- charged. Press the lever and open the dust cap. Tip the rear of the tool down to empty the dust box. Cleaner cutting operations can be per- formed by connecting this tool to Makita vacuum cleaner. Remove the rubber cap from the dust cap and connect the hose of vacuum cleaner to the dust cap. Switch action CAUTION: Before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" Dosition when released. To prevent the switch trigger from being accidentally pulled, a lock-off button is prc- Switch trigger - vided. LOCk-off button1 To start the tool, depress the lock-off but- ton and pull the switch trigger. Release the switch trigger to stop. Guide rule The handy guide rule allows you to do extra-accurate straight cuts. Simply slide the guide rule up snugly against the side of the workpiece and secure it in position with the clamp screw on the front of the base. It also makes repeated cuts of uniform width possible. ASSEMBLY Removing or installing the saw blade CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before installing or removing the blade. To remove the blade, first remove the hex socket head bolt which secures the dust box, then remove the dust box. Thumb screw - After installing the blade, install the dust box and tighten the hex socket head bolt to secure the dust box. To remove the blade, press the shaft lock so that the blade cannot revolve and use the hex wrench to loosen the bolt clock- wise. Then remove the bolt, outer flange and blade. Hex wrench (Counterclockwise) Then remove the ...
Other models in this manual:Saws - 5026DA (1.1 mb)
Saws - 5046DWA (1.1 mb)
Saws - 5026DB (1.1 mb)
Saws - 5026DWA (1.1 mb)