Votes - 3, Average rating: 5
(
)
)
|
manual abstract
14 Miter Gauge (optional accessory) ................................................................................................... 14 Tilting the Table............................................................................................................................. 15 Height Scale Adjustment................................................................................................................ 15 Changing Blades........................................................................................................................... 16 Replacing V-Belt ........................................................................................................................... 17 Adjusting Belt Tension................................................................................................................... 17 Electrical Connections ................................................................................................................... 18 Maintenance ................................................................................................................................. 18 Upper Blade Guide Adjustment ...................................................................................................... 10 Troubleshooting ................................................................................................................................ 19 Parts ................................................................................................................................................ 19 Replacement Parts........................................................................................................................ 19 Upper Wheel Assembly ................................................................................................................. 20 Lower Wheel and Motor Assembly ................................................................................................. 22 Blade Guides Assembly................................................................................................................. 24 Table Assembly............................................................................................................................. 26 Fence & Miter Assembly (optional accessory) ................................................................................. 28 Wiring Diagram................................................................................................................................. 30 3 1. Read and understand the entire owner's manual before attempting assembly or operation. 2. Read and understand the warnings posted on the machine and in this manual. Failure to comply with all of these warnings may cause serious injury. 3. Replace the warning labels if they become obscured or removed. 4. This band saw is designed and intended for use by properly trained and experienced personnel only. If you are not familiar with the proper and safe operation of a band saw, do not use until proper training and knowledge have been obtained. 5. Do not use this band saw for other than its intended use. If used for other purposes, Walter Meier (Manufacturing) Inc., disclaims any real or implied warranty and holds itself harmless from any injury that may result from that use. 6. Always wear approved safety glasses/face shields while using this band saw. Everyday eyeglasses only have impact resistant lenses; they are not safety glasses. 7. Before operating this band saw, remove tie, rings, watches and other jewelry, and roll sleeves up past the elbows. Remove all loose clothing and confine long hair. Non-slip footwear or anti-skid floor strips are recommended. Do not wear gloves. 8. Wear ear protectors (plugs or muffs) during extended periods of operation. 9. Some dust created by power sanding, sawing, grinding, drilling and other construction activities contain chemicals known to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are: • Lead from lead based paint. • Crystalline silica from bricks, cement and other masonry products. • Arsenic and chromium from chemically treated lumber. Your risk of exposure varies, depending on how often you do this type of work. To reduce your exposure to these chemicals, work in a well-ventilated area and work with approved safety equipment, such as face or dust masks that are specifically designed to filter out microscopic particles. 10. Do not operate this machine while tired or under the influence of drugs, alcohol or any medication. 11. Make certain the switch is in the OFF position before connecting the machine to the power supply. 12. Make certain the machine is properly grounded. 13. Make all machine adjustments or maintenance with the machine unplugged from the power source. 14. Remove adjusting keys and wrenches. Form a habit of checking to see that keys and adjusting wrenches are removed from the machine before turning it on. 15. Ke...