19 English OPTIONAL ACCESSORIES …………… sold separately (1) Straight Guide Set (Code No. 323-342) 1Bar Holder (Code No. 323-343) 2Feed Screw (Code No. 956-793) 3Wing Bolt (Code No. 301-806) 4Guide Bar (Code No. 323-345) 5Straight Guide (Code No. 323-344) 1234 5 (2) Dust Collector Set (Code No. 323-346) NOTE: Specifications are subject to change without any obligation on the part of the HITACHI. Francais INFORMATIONS IMPORTANTES DE SECURITE Lire et comprendre toutes les precautions de securite, les

Priere de lire et de comprendre ce mode d’emploi AVANT d’utiliser l’outil motorise. Garder ce mode d’emploi a la disponibilite des autres utilisateurs et proprietaires avant qu’ils utilisent l’outil motorise. Ce mode d’emploi doit etre conserve dans un endroit sur. INSTRUCCIONES DE SEGURIDAD Y MANUAL DE INSTRUCCIONES ADVERTENCIA .La utilizacion INAPROPIADA O PELIGROSA de esta herramienta electrica puede resultar en lesiones de gravedad o la muerte! Este manual contiene informacion importante sob

(6) Maintain tools with care. Keep cutting tools sharp and clean. Properly maintained tools, with sharp cutting edges are less likely to bind and are easier to control. (7) Check for misalignment or binding of moving parts, breakage of parts, and any other condition that may affect the tool's operation. If damaged, have the tool serviced before using. Many accidents are caused by poorly maintained tools. (8) Use only accessories that are recommended by the manufacturer for your model. Accessorie

Failure to do so will result in damage to the collet chuck. 2. Removing bits When removing the bits, do so by following the steps for installing bits in reverse order. Motor Housing Base Lever Wrench Bit Collet Chuck 16mm Loosen Tighten Wrench Fig. 3 English INSTALLING THE MOTOR HOUSING WARNING: Be sure to switch power OFF and disconnect the plug from the receptacle to avoid serious trouble. 1. Installing the motor housing (1) Open the lever. (2) While holding the base, insert the motor housing