Votes - 3, Average rating: 4.3 ( )

Manafacture: Broan File size: 118.27 kb File name: Language of manual:

See "OPTIONAL WIRING CONVERSIONS" section on pages 2 and 3 for wattage and voltage conversion instructions. Follow these basic steps when installing this heater: • Remove the housing mask. • Fasten finish assembly inside housing. • Plug assembly in. • Attach grille. WALL STUD POWER CABLE GRILLE HEATER HOUSING DRYWALL INSTALL THE HEATER ASSEMBLY 1. Remove housing mask. Make sure wall has been finished (including paint or wall paper, etc.) Take out and discard the cardboard mask from inside of housing. TABS FASTEN TO HOUSING WITH RETAINING SCREW - HERE 2. Install heater assembly into housing. Place element end of heater assembly behind the tabs on the left side of housing. Pivot the assembly in and fasten with retaining screw from parts bag. Plug wiring harness into receptacle. 3. Provide desired control. The heater finish assembly has no adjustable thermostat control. If a wall-mounted control has been pre-wired, nothing else need be done. If a built-in thermostat is desired, purchase and insert the Broan Model 83 Integral Thermostat at this time. WIRING DIAGRAM OPTIONAL WIRING CONVERSIONS 1. Conversion to half-wattage. The heater will produce less heat and use less electricity if converted to half-wattage. Disconnect ONE of the black wires with an insulated termi- nal from the motor. BLACK WIRES (connected to motor) WHITE WIRES BLACK WIRE (from motor) 2. 120 VAC to 240 VAC Conversion. (Factory-wired 120 VAC Models 170F and 174F ONLY) 1) Disconnect ONE of the black wires with an insulated terminal from the motor. 2) Disconnect the two (2) white wires with insulated terminals from each other. Do not remove wire from beneath plastic wire tie. 3) Connect black wire to white wire. NOTE: When heater is converted from 120 VAC to 240 VAC, half-wattage conversion is not possible 2 COMPLETE THE INSTALLATION USE AND CARE WARNING DISCONNECT ELECTRIC POWER AT SERVICE ENTRANCE BEFORE CLEANING OR SERVICING UNIT. 1. Attach grille. Fasten grille to heater with two (2) screws from parts bag. 2. Check operation. Turn on power at service entrance. Turn thermostat to its highest setting and make sure heating element and blower come on. Then turn it to its lowest setting and make sure element and blower shut off. THERMAL OVERLOAD PROTECTOR If heater fails to operate when thermostat is turned to its highest setting: Turn power off at service entrance. Remove grille and press button marked "RESET". CLEANING Clean the heater using the round brush tool on your vacuum cleaner. Remove large accumulations of dust, lint, etc., that might impede the flow of air through the heater. Such blockage will lower its efficiency and create a possible over-heating condition. To clean grille, use a soft cloth which has been moistened with household window cleaner. CAUTION: METAL AND ELECTRICAL PARTS SHOULD NEVER BE IMMERSED IN WATER. Broan-NuTone LLC One Year Limited Warranty Broan-NuTone LLC warrants to the original consumer purchaser of its products that such products will be free from...

Download now

Please, enter two numbers from picture: