Votes - 5, Average rating: 3.6
(
)
)
|
Other manuals for this model:
Desktops - Aspire M1100 (1.05 mb)
Desktops - Aspire M1100 (788.79 kb)
Desktops - Aspire M1100 (321.51 kb)
manual abstract
3 Replace the side panels. 4 Connect the necessary cables and turn on your computer. Opening your computer Caution: Before you proceed, make sure that you have turned off your computer and all peripherals connected to it. Read the "Preinstallation instructions" on page 10. You need to open your computer before you can install additional components. See the following section for instructions. To remove the computer cover 1 Turn off your computer and unplug all cables. 2 Place your computer on a flat, steady surface. If your computer is in the vertical position, remove the foot stands and place your computer in the regular desktop position. 3 Turn the screws counterclockwise to release the cover. 4 Hold the sides of the cover with both hands. 5 Slide it back about an inch and then gently lift it upward to detach it. To replace the computer cover 1 Align the cover’s hinges to the housing frame; then gently push it in to slide it back into place. 2 Secure the cover with the screws. Upgrading your computer 12 Certain components of your computer are upgradeable, such as the memory, the hard disk, the CPU and the expansion cards. You need to observe the "Installation precautions" on page 10 when installing or removing a computer component. However, for safety purposes, we do not recommend that you perform these upgrades yourself. If you want to replace or upgrade any of these components, contact your dealer or a qualified service technician for assistance. To remove a DDR2 DIMM Note: The DDR2 DIMM has only one notch located toward the center of the module. 1 Remove the side panel. 2 Locate the DDR2 DIMM socket on the mainboard. 3 Press the holding clips on both sides of the DDR2 DIMM socket outward to release the DDR2 DIMM (a). Gently pull the DDR2 DIMM out of the socket (b). To install a DDR2 DIMM Locate the DDR2 DIMM socket on the mainboard. English EnglishEnglish 13 3 Upgrading your computer 2 Align the DDR2 DIMM with the socket (a). Press the DDR2 DIMM into the socket until the clips lock onto the DDR2 DIMM (b). Note: The DDR2 DIMM sockets are slotted to ensure proper installation. If you insert a DDR2 DIMM but it does not fit easily into the socket, turn the DDR2 DIMM around and try to insert it again. To reconfigure your computer Your computer automatically detects the amount of memory installed. Run the BIOS utility to view the new value for total system memory and make a note of it. Replacing the hard disk Follow these steps to replace your computer's hard disk: 1 Remove the computer cover. 2 Detach all cables connected to the hard disk and pull the hard disk out. 3 Remove the drive rails that hold the hard disk to the disk frame and detach the hard disk. Set the drive rails aside. 4 Insert the new hard disk into the frame and secure it with drive rails. 5 Reattach all cables to the new hard disk. 14 Note: Make sure that the other ends of the disk cables are securely connected to their corresponding connectors on the mainboard. 6 Reinstal...
Other models in this manual:Desktops - Aspire G1720 (312.55 kb)
Desktops - Aspire M1610 (312.87 kb)
Desktops - Aspire M3100 (312.56 kb)
Desktops - Aspire M5100 (312.56 kb)