Votes - 0, Average rating: 0
(
)
)
|
manual abstract
Press once for one cup. The coffee is ground, brewed and dispensed into the cup. Button 4 flashes during this process. Press twice within 3 seconds for two cups. The coffee is ground, brewed and dispensed into the cups (the grinding and brewing process takes place twice). Button 4 flashes and 6 (2 cups) appears on the display during this process. i If the coffee dispensing button 4 is pressed again, the coffee brewing process is terminated. 5 Coffee strength button 5 This button 5 is used to select the coffee strength: 5 mild 55 medium 555 strong The selected setting is shown on the display. 6 Standby button a Button a switches on the appliance or switches it to standby mode. When button a is pressed, the appliance heats up and button a flashes while the appliance heats up and is rinsed. When the buttons 4, 5, a and h light up and one, two or three beans (depending on the setting) appear on the display, the appliance is ready for operation. The appliance will not be rinsed if: – it was still warm when switched on, or – coffee was not discharged before it was switched to “standby“ mode, or – steam was discharged shortly before it was switched off. 7 Steam generation button h Button h generates steam for foaming or warming. 8 Steam dispensing dial Hot water or steam can be dispensed by turning the dial to hot water g or steam h. To dispense steam, the steam generation button h must be pressed first (see “Steam for foaming milk“). Settings and displays Setting the water hardness It is important that the water hardness be set correctly, so that the appliance indicates accurately when the descaling programme should be run. The factory setting is a water hardness of 4. You can check the water hardness using the enclosed test strip or by asking your local water supplier. Degree Water hardness German (°dH) French (°fH) 1 17 113 2 815 1427 3 1623 2842 4 2430 4354 e.g. en . Determinethewaterhardnesswiththeenclosed test strip. = Hardness 2 . Switch the device to standby. . Hold down the steam button h for at least 3 seconds. The number of service buttons 4, 5, a, h that light up indicate the selected water hardness. . Press the steam button h repeatedly until the correct number of buttons is lit. . Press button a once. The selected number of service buttons should light up briefly; this indicates that the desired water hardness setting has been saved successfully. If a water filter (special accessory) is used, the water hardness should be set to 1. Note: If no button is pressed within 90 seconds, the appliance switches to standby mode without saving the new settings. In this case, the previous water hardness setting is retained. The first time a filter is used or after changing the filter, the appliance needs to be cleaned. . Fill the water tank up to the 0.5l mark. . Place a suitable container (approx. 0.5 litres) under the nozzle 9. . Turn the dial 8 to g/h. . If no water comes out of nozzle 9, turn the dial back to O. . Fill the water tank and water pipe...
Other models in this manual:Coffee Makers - TK54001/02 (1.43 mb)
Coffee Makers - TK54001CH/01 (1.43 mb)
Coffee Makers - TK54001CH/02 (1.43 mb)
Coffee Makers - TK54001GB/01 (1.43 mb)