Votes - 0, Average rating: 0
(
)
)
|
manual abstract
1 en 4 Coffee dispensing button K (strong coffee) This button is used to dispense strong coffee. When the button is pressed, the coffee is ground, brewed and dispensed into the cup. 5 Steam generation button h The steam button hgenerates steam for foaming or warming. 6 Steam dispensing dial Hot water or steam can be dispensed by turning the dial to g or h. To dispense steam, the steam generation button h must be pressed irst (see “Steam for foaming milk”). 7 LED display The various LEDs indicate the following: H on The water tank is empty and needs to be illed I on Trays full: Empty and replace them I lashing Trays missing: Reinsert them S on Run the service programme (see “Service programme”) S lashing Service programme in operation J lashing Turn dial to g/h J on Turn dial to “O” Settings and displays Setting the water hardness It is important that the water hardness be set correctly, so that the appliance indicates accurately when the descaling programme should be run. The factory setting is a water hardness of 4. You can check the water hardness by asking your local water supplier. Degree Water hardness German (°dH) French (°fH) 1 1-7 1-13 2 8-15 14-27 3 16-23 28-42 4 24-30 43-54 . Switch the appliance to “eco” mode. . Hold down the steam button hfor at least 5 seconds. The number of LEDs 7a H, b I, c S, d Jthat light up indicates the selected water hardness. . Press the steam button hrepeatedly until the correct number of LEDs is lit; e.g. for a hardness of 3, the LEDs 7a, b and c (H, I, S) light up. . Press the button eco once. The selected number of LEDs should light up briely; this indicates that the desired setting has been saved successfully. If a water ilter (optional extra Order No. 461732) is used, the water hardness should be set to 1. Note: If no button is pressed within 90 seconds, the appliance switches to “eco” mode without saving the new settings. In this case, the previous water hardness setting is retained. The appliance must be rinsed when a ilter is irst used and after changing the ilter. . Fill the tank with water up to the “0,5 l” mark. . Place a suitable container (approx. “0,5 l”) under the nozzle 8. . Set the dial 6 to g/h. . When water stops coming out of the nozzle 8, set the dial back to “O”. . Fill the water tank and the water pipes (see “Switching on the appliance / Filling the system”). en Adjusting the grinding unit Sliding switch 15 adjusts the degree of grinding, from coarse to ine. Warning Adjust the grinding unit only while it is running! Otherwise the appliance may be damaged. . Press the strong coffee button K. . While the grinding unit is running, move the sliding switch 15 to the desired posi tion: the smaller the dots, the iner the grind. iThe new setting will not become apparent until the second or third cup is brewed. Tip: For dark roast coffee beans, choose a coarser grind; for light roast beans, select a iner grind. Float The loat 19 in the water tray 18 shows when the tray needs emptying. . If the ...
Other models in this manual:Coffee Makers - TK52001/02 (1.39 mb)
Coffee Makers - TK52001CH/01 (1.39 mb)
Coffee Makers - TK52001CH/02 (1.39 mb)
Coffee Makers - TK52002/01 (1.39 mb)