Votes - 0, Average rating: 0 ( )

Manafacture: Philips File size: 4.16 mb File name: Language of manual:

ENGLISH 49 1 Place a container under the coff ee dispensing spout. 2 Make sure the water tank is fi lled with fresh water up to the “MAX” level. 3 Put a “Coff ee Oil Remover” tablet in the pre-ground coff ee compartment. 4 Press the “ ” button one or more times to select the pre-ground coffee function. Do not add ground coff ee. 5 Press the “ ” button to start a coff ee brewing cycle. 6 Wait until the machine has dispensed half a cup of water. 7 Switch the power button on the back of the machine to “0”. Green 50 ENGLISH 12 After rinsing the brew group, insert it again in its seat until it locks into place (see the “Weekly Cleaning of the Brew Group” chapter). Insert the coff ee residues drawer and the coff ee grounds drawer. Close the service door. 13 Press the “ ” button to select the pre-ground coff ee function. Do not add coff ee to the pre-ground coff ee compartment. 14 Press the “ ” button to start a coff ee brewing cycle. 15 Repeat steps 13-14 twice. Empty the container. 16 To clean the drip tray, place “Coff ee Oil Remover” tablet inside and fi ll it 2/3rds full with hot water. Let the cleaning solution take eff ect for about 30 minutes, then rinse thoroughly. Green 10 Remove the coff ee grounds drawer and open the service door. Remove the coff ee residues drawer and then the brew group. 11 Wash the brew group thoroughly with fresh water. 8 Let the solution take eff ect for approximately 15 minutes. Make sure you discard the dispensed water. 9 Switch the power button on the back of the machine to “I”. To turn on the machine press the “ ” button. Wait until the automatic rinse cycle has been completed. ENGLISH 51 Yellow DESCALING The descaling process takes approx. 35 minutes. Limescale builds up inside the machine during use. It needs to be removed regularly as it may clog the water and coff ee circuit of your machine. The machine tells you when descaling is needed. If the machine display shows the CALC CLEAN icon, it means that you need to descale. Caution: Not doing this will ultimately make your machine stop working properly, and in this case repairing is NOT covered by your warranty. Use the Descaling solution only. Its formula has been designed to ensure better machine performance. You can purchase separately the Descaling solution. Please refer to the maintenance products page in this user manual for further details. Warning: Never drink the descaling solution or any products dispensed until the cycle has been carried out to the end. Never use vinegar as a decalcifi er. Note: During the descaling cycle do not switch off the machine. If this has happened you have to restart the descaling cycle to fully complete it. It will restart from the point the descaling cycle had previously been left. To perform the descaling cycle, follow the steps below: Before descaling: 1 Empty the drip tray. 2 Remove the Automatic Milk Frother from the steam/hot water wand. 3 Remove the “INTENZA+” water fi lter from the water tank if it was installed and replace it with the small white original one. Place the water tank back into the machine. 52 ENGLISH 4 Press the “ ” MENU button and scroll the pages by pressing the “ ” MENU button until the following icon is displayed. 5 Press the “ ” button to start the descaling process. Note: If you press the “ ” button by mistake, press the “ ” button to quit. 6 Remove the water tank and pour the entire content of the descaling solution. Then fi ll the water tank with fresh water up to the CALC CLEAN level. 7 Place the water tank back into the machine. Yellow Yellow 8 Place a large container (1.5 l) under both the steam/hot water wand and the dispensing spout. Green ENGLISH 53 5353 9 Press the “ ” button to start the descaling cycle. 10 The machine will start dispensing the descaling solution at intervals. The bar on the display shows the cycle progress. Note: The descaling cycle may be paused by pressing the “ ” button .To resume the cycle, press the “ ” button again. This allows you to empty the container or to stay away from the machine for a brief period of time. 11 When this icon is displayed, the water tank is empty. 12 Remove and empty the container. 13 Empty the drip tray and place it back. Red YellowYellow Yellow 54 ENGLISH Yellow Green Red Yellow 14 Remove the water tank, rinse it and fill it up to the MAX level with fresh water. Place it back into the machine. When inserting the water tank into the machine, the display on the left is shown. 15 Put the container back under both the steam/hot water wand and the dispensing spout. 16 Press the “ ” button to start the rinsing cycle. 17 When this icon is displayed, the water tank is empty. Repeat steps 12 to 16. Then go to step 18. 18 When the water tank is empty, remove the water tank, rinse it and fi ll it up to the MAX level with fresh water. Place it back into the machine. 19 Empty the container and place it back under both the steam/hot water wand and the dispensing spout. 20 When the amount of water needed for the rin...

Download now

Please, enter two numbers from picture: