Votes - 3, Average rating: 4.3 ( )

Manafacture: Regency File size: 1 mb File name: Language of manual:

If this happens, it is preferable to contact your nearest dealer to get the appliance serviced. REPLACEMENT PARTS An exploded view of the room heater with numbered parts and a parts list can be found on pages 20 and 21. All parts should be ordered through your Lennox distributor or dealer. Parts will be shipped at prevailing prices at time of order. When ordering repair parts, always give the following information: 1. The model number of the heater. 2. The serial number of the heater. 3. The part number. 4. The description of the part. 5. The quantity required. 6. The installation date of the heater. If you encounter any problems or have any questions concerning the installation of this heater, please contact your distributor. For the name of your nearest distributor contact: LHP 1110 West Taft Avenue Orange, CA 92865 S Forced Air Kit FAB-1100 Refractory Liner Kit VF5RLK Gas Flex Line Kit FFGC Square Trim Kit STK-5-4 Decorative Volcanic Stone FDVS Brass Louver Kit BRLK-5C Wall Switch Kit FWSK Wood Surround-Wall SUR-5PW Rocker Switch Kit FRS Remote Control RCL Wood Surround-Corner SUR-5PC Thermostat WTK BSK-5 Brass Surround Kit BRLK-CS NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE. VF4000 SPECIFICATIONS 37" (940 mm) 31-1/2" (800 mm) 30" (762 mm) 15" (381 mm) 36" (914 mm) Front View 5-1/2" (140 mm) 37" (940 mm) 31-1/2" (800 mm) J Box Opening Gas Line Opening 8" (203 mm) 3-3/4" (95 mm) 3-1/2" (89 mm) 1/2" (13 mm) 3" (76 mm) 15-1/2" (394 mm) Left Side View (Right Side View - Opposite) 27" (686 mm) 15-1/2" (394 mm) 36" (914 mm) Top View Figure 21 NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE. VF4000-CHM/P OPERATING INSTRUCTIONS (STANDARD VALVES) FOR YOUR SAFETY READ BEFORE LIGHTINGLIGHTING INSTRUCTIONS1.Stop! Read the safety information above. 2.Make sure manual shut-off valve is fully open. 3.Locate gas control knob and piezo. 4.Depress control knob in and turn clockwise to the“OFF” position (Figure 22). 5.Wait 5 minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow “B” inthe safety information above. If you do not smell gas, go to thenext step. 6.The pilot is located on the right side in front of the burner(Figure 23). 7.Depress control knob in and turn counterclockwiseto the “IGN” position (Figure 24). Press the control knob allthe way in for 5 seconds. Note:If you are running the heater for the first time it will benecessary to press the control knob all the way in for 30seconds to allow air to bleed out of the gas piping. MANUAL MATCH LIGHTING PROCEDURE — EMERGENCY ONLY1.If the pilot cannot be lit with the piezo igniter, the heater can bemanually lit with a match. 2.With the right hand, depress and turn the control knobcounterclockwise to the “ON” position. Hold in theknob. TO TURN OFF GAS TO HEATER1.Depress and turn control knob clockwise to the “OFF” position (Figure 22). 3.Light the match and hold the flame to the end of the pilot andignite the pilot. 4.Continue to hold control knob for an additio...

Download now

Please, enter two numbers from picture: