Votes - 3, Average rating: 3.7 ( )

Manafacture: Gas-Fired Products File size: 519.25 kb File name: Language of manual:

4 Vent options to provide additional air. Vermont Castings Radiance Vent-Free Gas Heater Assembly Procedures Read these instructions thoroughly before starting the assembly. Follow procedures in the order given. Inspect the stove for damage before starting the assembly. Do not install this stove if any damage is evident. Contact your dealer immediately. The Radiance is shipped on its back, mounted to a wooden pallet. It is fully assembled, although packing materials must be removed from the firebox and the Log Set installed. Connection to the gas supply must be performed only by a qualified gas technician who should also verify that adequate ventilation is available to support proper burner function. Installation of optional accessories, such as the Fan, Glass/Catalyst, or thermostat, is most easily accomplished before the gas supply connection is made. Tools Required • Stub-handled Phillips screwdriver • work gloves • Standard Phillips screwdriver • knife • Standard flat-blade screwdriver •Tape measure • needlenose pliers Hardware Bag Contents • Porcelain Handle (Front Door) • Control Door Handle & Screw • (2) Bags of Lava Rock • (6) 10 x 1/2” Screws • Bracket, Wire Switch • Registration Card & Manual • (4) CS, Hex Hd 3/8-16 x 1 Gr 2-Z • (4) Washer, Fl 3/8-Z Unpacking the Radiance Caution: Enamelled castings can chip easily! Handle enamelled castings carefully to avoid damage. 1. Cut the shipping straps. 2. Unpack the top grate and screen from the carton, and set them aside. Remove the Front, Screen and Logs Remove the Front panel, the Screen panel, the Log Set and hardware bag from the firebox before positioning the stove. 1. Remove the accessory package from the top of the stove. The manual, hardware package, and lava rocks are packed on top of the firebox. Set these aside. 2. Remove the Front Plate. Grasp one side and the bottom, and lift the front plate as a unit (the control door attaches to the stove front). Swing the bottom edge out and away from the stove body, (Fig. 5) 3. Remove the screen frame. (Fig. 6) 4. Remove the Log Set. Lift out the package and any packing material from the burner tray and firebox. Unpack the log set and inspect each piece for damage. DO NOT INSTALL DAMAGED LOGS. Set the logs aside out of the way. ST139 Fig. 5 Remove the front plate. ST187a Screen Hooks Fig. 6 Lift screen from firebox. Vermont Castings Radiance Vent-Free Gas Heater Assemble the Legs 1. Slide stove to the rear of the pallet just far enough to access rear leg holes. Make sure the stove does not tip over backwards. (Fig. 7) ST720 Fig. 7 Slide stove back just far enough to access rear leg holes. 2. Attach the rear legs using 3/8” hex head bolts and flat washer supplied. Tighten with a 9/16” wrench or socket. 3. Carefully tip the stove onto its rear legs. Adjust the pallet to allow access to one of the front leg holes. Be sure to leave the pallet under the stove to prevent the stove from falling fully forward. (Fig. 8) CAUTION: To prevent valve tubing from being crushed or damaged, make sure to rest valve on wooden pallet. Washer Hex Head BoltST721 Fig. 8 Carefully tip stove onto back legs. Leave pallet under stove to keep stove from falling fully forward. 4. Have your assistant attach one leg using the...

Download now

Please, enter two numbers from picture: