Votes - 3, Average rating: 4.7
(
)
)
|
manual abstract
Any other use not recommended by the manufacturer may cause fire, electrical shock, or injury to persons. 4.Make certain that the room is equipped with a working smoke detector. 5. Make certain that the power source conforms to the electrical requirements of the Heater. 6. Extreme caution is necessary when any Heater is used by or near children or invalids and whenever the Heater is left operating unattended. 7. This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug is intended to fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to defeat this safety feature. 8.Do not operate any Heater with a damaged cord or plug or after the Heater malfunctions, or has been dropped or damaged in any manner. Please contact Customer Service at 800-233-0268 Monday through Friday from 8am to 5pm EST for assistance. 9.To disconnect Heater, turn the Heater OFF then remove the plug from the outlet. 10. Always unplug Heater when not in use. Unplug power cord before servicing or moving the Heater. 11. Do not insert or allow fingers or foreign objects to enter any ventilation or exhaust opening as it may cause an electric shock, fire, or damage the Heater. Do not block or tamper with the Heater in any manner while it is in operation. 12.To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not place on soft surfaces, like a bed, where openings may become blocked. 13.Always place the Heater on a stable, flat, level surface when operating, to avoid the chance of the Heater overturning. Locate the Power Cord so the Heater or other objects are not resting on it. DO NOT run Power Cord under carpeting. DO NOT cover Power Cord with throw rugs, runners, or the like. Arrange Power Cord away from room traffic and where it will not be tripped over. 14. This Heater is HOT when in use. To avoid burns, do not let bare skin touch hot surfaces. Always use handle when moving this Heater. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes and curtains at least 3 feet (0.9 m) from the front of the Heater and keep them at least 1 foot (0.3 m) from the sides and rear. 15.A Heater has hot and arcing or sparking parts inside. DO NOT use the Heater in areas where gasoline, paint, or flammable liquids are used or stored. DO NOT use Heater in locations where flammable or explosive chemicals are stored, or in wet atmospheres. This Heater is intended for general use ONLY. 16.This Heater is not intended for use in wet or damp locations. This Heater is not intended for use in bathrooms, laundry areas and similar indoor locations. NEVER locate a Heater where it may fall into a bathtub or other water container. 17.DO NOT use Heater outdoors. 18.Remote controls for other appliances or electronic equipment can sometimes interfere with the operation of this Heater. If this occurs, move the Heater to another location. 19.Keep Heater remote control unit away from chairs and your bed where it may be sat or laid upon and inadvertently turn on the Heater. 20. This Heater is not suitable for use in agricultural facilities including areas where livestock, poultry or other animals are confined. Please refer to National Electric Code (NEC) Article 547-7 (2002), or applicable state or local codes or standards relating to electrical requirements for Agricultural Buildings. THIS HEATER DOES NOT MEET THE REQUIREMENTS OF NEC ARTICLE 547-7 (2002). 21. This Heater is not suitable for use in hazardous locations. Please refer to National Electric Code (NEC) Article 500 or applicable state or local codes or standards relating to electrical requirements for Hazardous locations. THIS HEATER DOES NOT MEET THE REQUIREMENTS OF NEC ARTICLE 500 (2002). WARNING: REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK – DO NOT USE THIS HEATER WITH ANY SOLID STATE SPEED CONTROL DEVICES. Figura 2 DO NOT DEPEND ON THE ON/OFF SWITCH AS THE SOLE MEANS OF DISCONNECTING POWER WHEN SERVICING OR MOVING THE HEATER. ALWAYS UNPLUG THE POWER CORD. ALWAYS TURN OFF AND UNPLUG HEATER BEFORE LEAVING THE AREA. NEVER LEAVE CHILDREN UNATTENDED WHEN THE HEATER IS ON OR PLUGGED IN. Pantalla al ser encendido por primera vez La pantalla refleja calor Alto y Funcion de Control Automatico de Temperatura Luz de Encendido Figura 3 Figura 1 El gancho del control remoto esta ubicado en la parte posterior del calefactor. (Figura 4) Vista Posterior del Calefactor SAVE THESE INSTRUCTIONS Figura 4 New 2/07 2 5570ES New 2/07 7 5570ES MODEL 5570 INFORMACION GENERAL DE SEGURIDAD Al usar artefactos electricos, siempre deben tomarse precauciones basicas para reducir el riesgo de incendio, choque electrico y lesiones a personas, incluyendo las siguientes: Timer Function in High Heat and Automatic Temperature Control Timer Function in LOW Heat OPERATION (Figures 1 through 3) 1.Carefully remove the H...