Votes - 1, Average rating: 4
(
)
)
|
manual abstract
Dutchwest noncat cover 5/04 Homeowner’s Installation and Operating Manual If this heater is not properly installed, operated, and maintained, a house fire may result. For safety, follow all installation, operation and maintenance directions. Contact local building officials about restrictions and installation inspection requirements in your area. SAFETY NOTICE Non-Catalytic Convection Heater Model 2478 Dutchwest Non-Catalytic Convection Heater The Dutchwest Model 2478 covered in this Owner’s Guide has been tested and listed by OMNI - Test Laboratories, Inc. of Beaverton, Oregon. The test standards utilized were UL 1482 for the United States and ULC S-627 for Canada. Dutchwest Model 2478 is not listed for mobile home installations. This heater meets the U.S. Environmental Protection Agency’s emission limits for wood heaters sold on or after July 1, 1990. PLEASE NOTE Read this entire manual before you install and use your new room heater. Failure to follow instructions may result in property damage, bodily injury or loss of life. Save these instructions for future use. Table of Contents Specifications ............................................................ 3 Installation ..........................................................4 Clearances .......................................................10 Assembly..........................................................16 Operation..........................................................18 Maintenance.....................................................23 Illustrated Parts List..........................................30 Warranty ...........................................................32 Accessories • • • • • • Clearance-reducing Right Side Heat Shields Clearance-reducing Heat Shields for single-wall stove pipe Variable-speed Blower Outside Air Termination Kit Clearance Reducing Rear Exit Flue Heat Shield Clearance Reducing Top Exit Flue Heat Shield Proposition 65 Warning: Fuels used in gas, wood- burning or oil fired appliances, and the products of combustion of such fuels, contain chemicals known to the State of California to cause cancer, birth defects and other reproductive harm. California Health & Safety Code Sec. 25249.6 Patents: U.S.: D288357, 4502395, 4646712 Resolute Acclaim: 4683868,D308246 Canada: 1235969. Other foreign mechanical patents issued. 3 Dutchwest Non-Catalytic Convection Heater 30002278 1. Maximum burn times and heat outputs are based on laboratory testing using full loads of seasoned hardwoods, and may vary in individual use depending on how the stove is operated, type and moisture content of fuels, and other factors. Maximum burn times are achieved under different operating conditions than are maximum heat outputs. 2. These values are based on operation in building code-conforming homes under typical Winter climate conditions in the northeastern U.S. If your home is of nonstandard construction (e.g. unusually well-insulated, not insulated, built underground, or if you live in a more severe or more temperate climate), these figures may not apply. Since so many variables affect performance, consult your Dutchwest Authorized Dealer to determine realistic expectations for your home. 4. Under specific conditions used during EPA emissions testing. Specifications Fig. 1 Dutchwest Convection Heater specifications. Model 2478 A 26...” (683 mm) B 27...” (695 mm) C 29...” (756 mm) D 23” (584 mm) E 17... ” (445 mm) F 27...” (692 mm) Center of Flue Collar, Rear Exit G 30...” (775 mm) H 5...” (146 mm) Log length 22” (560 mm) Maximum burn time1 Up to 10 hrs. Average area heated (sq. ft.)2 800 - 1600 (74 - 149 m2) Range of heat output4 10,600 - 25,300 Btu/hr. Maximum heat output1 40,000 Btu/hr. EPA emissions rating4 (g/h, non-catalytic) 1.49 Weight 420 lbs. (191 kg) Loading Side or front Flue exit position (reversible) Top or rear Air control One G F E D C B A 2278 Dutchwest noncat specs 5/04 H Dutchwest Non-Catalytic Convection Heater Installation SAFETY NOTICE: IF YOUR DUTCHWEST CONVECTION HEATER IS NOT PROPERLY INSTALLED, OPERATED AND MAINTAINED, A HOUSE FIRE MAY RESULT. FOR SAFETY, FOLLOW ALL INSTALLATION, OPERATION AND MAINTENANCE DIRECTIONS. CONTACT LOCAL BUILDING OFFICIALS ABOUT RESTRICTIONS AND INSTALLATION INSPECTION REQUIREMENTS IN YOUR AREA. Before you begin the installation, review your plans to confirm that: • Your stove and chimney connector will be far enough from combustible material to meet all clearance requirements. • The floor protector is large enough and is constructed properly to meet all requirements. • You have obtained all necessary permits from local authorities. Your local building official is the final authority for approving your installation as safe and for determining that it meets local and state codes. Clearance and installation information is printed on the metal label attached to the rear of the stove. Local authorities generally will accept the label as evidence that, when the stove is installed according to th...