Votes - 2, Average rating: 4
(
)
)
|
manual abstract
-Push the heater upwards so that it leans toward the bracket, and the upper hooks slide into place. 3. Heating 3.1 Function of the service elements Turn on switch A when the heating period starts. Lamp B lights when the heater is emitting heat. The thermostat dial C is for setting the desired room temperature, which will then remain constant. Depending on where the heater is installed, it may happen that the room temperature and the temperature shown on the thermostat dial do not agree. In this case we recommend that the adjustment wheel is adjusted as follows: Turn the heater on. Turn the thermostat dial up to the maximum (the lamp lights). Turn the thermostat dial back again until the lamp goes out. If you can see that there is a difference between the reading on the thermostat dial and the room temperature, make the adjustment as follows: Hold the adjustment wheel steady, and set the dial with the temperature settings to the appropriate value using a small screwdriver or something similar. Important: Wait until the heater has been on for about 24 hours before you make this adjustment. 3.2 Lowering the temperature For regular reduction of the temperature, you can use our energy-saving cassette 2NC9 712 (extra accessory). Heater Typ 2NC2 9..-1A can additionally be controlled by an external timer. You can start the appropriate program at the touch of a button, or set the temperature reduction period on the timer (see the connection diagram regarding connection). The room temperature will be lowered by up to 5° C during the temperature reduction period. 4. Important information about using the heater NB: The heater element has been coated with a protective oil that will evaporate the first time the heater is switched on. This means that a harmless vapour may be released when the heater is switched on for the first time. For your safety, the heater is protected against overheating. If the air circulation is obstructed, for example by something hanging or set up in front of the air grille, the heater will cut out automatically. After the obstructing object has been removed, the heater will resume normal operation after about 15 minutes. To attain full heating power, the openings allowing air to flow in and out must be kept free of dust. Please vacuum clean the heater before the start of the heating season. 5. Problems in operation If the heater is not emitting any heat, first check that it is switched on and that the thermostat dial is set to the appropriate temperature. Then check that the automatic cut-out fuse has not tripped. If the latter applies, contact your electrician. Specify the E-number, which you will find on the plate indicating the power (upper right of the heater). 6. Specifications Power supply voltage Protection category Thermostat Overheating cut-out : : : : 1/N/PE 230V, 50 Hz Class I, IP21 Electronic, 5° to 30° C Automatic, resetable 7. Accessories Cover for Switch and Thermostat dial 2NC9 710 Electronic Energy-saving plug-in Cas...
Other models in this manual:Electric Heaters - 576.056A (132.99 kb)