Votes - 0, Average rating: 0
(
)
)
|
Other manuals for this model:
manual abstract
-Do not expose the appliance to temperatures higher than 35°C. -Remove the batteries if you are not going to use the appliance for a month or more. -Do not leave empty batteries in the appliance. Inserting batteries 1 2 To remove the battery compartment cover, pull it off the appliance (Fig. 3). Put the batteries in the battery holder (Fig. 4). Note: Make sure that the + and - poles of the batteries point in the right direction. 3 Push the battery compartment cover back onto the appliance (‘click’) (Fig. 5). Attaching/detaching the shaving head 1 2 To detach the shaving head, press the release buttons on both sides of the appliance (1) and pull the shaving head (2) (Fig. 6). To attach the shaving head push it onto the appliance. Note: Do not exert pressure on the shaving foil to avoid damage. Attaching/detaching attachments HP6342 comes with the protection cap, the efficiency cap and the trimming comb. HP6340 comes with the protection cap. All attachments can be attached and detached in the same way. 1 2 To attach a cap or comb, carefully push it onto the appliance. Make sure the recess of the comb is aligned with the front of the appliance (Fig. 7). To detach a cap or comb, carefully pull it off the appliance (Fig. 8). Note: Do not hold the comb by its teeth when you pull it. Using the appliance The Ladyshave is suitable for : -Shaving the underarms -Shaving the legs -Shaving the bikini line -Trimming the bikini line (HP6342 only) Use on wet skin You can use the Ladyshave on wet skin, while you have a bath or shower.To achieve the best result, lather your skin with soap or shaving cream beforehand. Use on dry skin If you prefer to use the Ladyshave dr y, make sure that your skin is clean and completely dry. Note: in principle, there is no difference in using the appliance on wet skin and using it on dry skin.You can simply choose which method you like best. Note: Do not apply alcohol based-lotions to the skin directly before or after shaving. If you want, you can apply some talcum powder. Note: Do not press the shaving head too hard onto the skin, as this has a negative effect on shaving performance and may cause some skin irritation. Shaving 1 2 3 4 1 Legs and bikini line Press the on/off slide upwards to switch on the appliance (Fig. 9). Hold the appliance at an angle of approximately 70°. Make sure that the shaving foil and pre-trimmer are fully in contact with your skin (Fig. 10). Stretch the skin with your free hand to make the hairs stand upright. Move the appliance gently over the skin against the direction of hair growth (Fig. 11). Underarms When you shave the underarm area, place one arm behind your head to stretch the skin (Fig. 12). 2 Move the Ladyshave gently over the skin.To achieve the best result, move the Ladyshave up and down and from left to right (Fig. 13). Efficiency cap (HP6342 only) If you are new to shaving, you can use the efficiency cap to help you place the Ladyshave on the skin at the optimum angle. When the efficiency cap is placed flat on the skin, the shaving foil and trimmer are fully in contact with the skin.This helps to get perfect results. Trimming (HP6342 only) If the hair you want to shave is longer than 10mm, pre- trim the hair with the trimming comb to a length of 3mm for an optimal shaving performance. 1 2 3 Attach the trimming comb onto the appliance. Press the on/off slide upwards to switch on the appliance (Fig. 9). Move the appliance against the direction of hair growth. Make sure that the surface of the comb is in full contact with the skin at all times (Fig. 14). Note:You will achieve the best result if you trim under dry conditions. Cleaning and maintenance Regular cleaning and proper maintenance ensure optimal results and guarantee a long life for the appliance. Clean the Ladyshave after each use. Do not clean, rinse or immerse the Ladyshave in water if the cover of the battery holder is not closed properly. Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone to clean the appliance. 1 2 3 Switch off the appliance (Fig. 15). Detach the shaving head from the appliance (see chapter ‘preparing for use’). Remove the shaving unit from the shaving head (Fig. 16). Note: Do not exert too much pressure on the shaving foil to avoid damage. 4 To clean the shaving head and shaving unit, rinse them under the tap or use the cleaning brush (Fig. 17). Note: Do not clean the appliance with water above shower temperature. 5 6 Rinse the hairs off the appliance (Fig. 18). Make sure the appliance is completely dry before you reattach the shaving unit (Fig. 19). Maintenance 1 2 Lubricate the shaving foil with a drop of sewing machine oil twice a year (Fig. 20). Apply some vaseline to the rubber sealing ring from time to time to keep the Ladyshave watertight. Storage 1 Put the protection cap on the appliance. Note:The protection cap prevents the shaving head from becoming damaged. 2 HP6342 only: Store the appliance and accessories in the...
Other models in this manual:Shavers - HP6341/00 (1.25 mb)