Votes - 1, Average rating: 5
(
)
)
|
manual abstract
( For best results, no more than 3 racks should be used) Blower Fan and Motor: 1/3 hp, 1725 rpm, 60 cycle, 115V AC, high efficiency, permanent split phase motor with permanent lubricated ball bearings, overload protection and Class “B” insulation. Motor mounted to rear of oven. Motor serviceable from front of oven through oven cavity. Electrical System: Wired for single phase, 115V AC with 6’ cord and 3-prong plug supplied with each deck. Gas Control System: Includes pressure regulator, flame switch safety, pilot filter, pilot adjustment Oven Heating: Aluminized steel bar burner. Dual flow fan recircu lates heat directly from combustion area and within oven cavity. Controls: Oven thermostat temperature type adjustable for 250° 500° F with a low setting. Form 460-3G4G Rev 4 (04/07) Printed in USA .. 460DD-3G .. 460AD-3G .. 460AA-3G Models: .. 460DD-4G .. 460AD-4G .. 460AA-4G Dimensions -in (mm) OPTIONS AND ACCESSORIES NOTES: 1. Optional -Hot Plate in lieu of 2 open top burners at 12,000 BTU/ burner (24,000 BTU total NAT or LP) 2. Thermostat griddle control with 1 throttling-type thermostats. Temperature range of 100° to 450°F (add prefix T). ..10” Flue Riser ..3/4” quick disconnect with flexible hose complies with ANSI Z 21.69 (specify 3ft, 4ft, 5ft) ..Casters-all swivel-front with locks ..Hot Top plates - each plate replaces 2 Open burner section ..Various salamander & cheesemelter mounts available. (Please refer to the price list) ..Auxillary griddle plates ..Extra Oven Racks ..Cabinet Base MISCELLANEOUSUTILITY INFORMATION -If using Flex-Hose, the I.D. should not be smaller than 3/4” and must comply with ANSI Z 21.69 -If casters are used with flex hose, a restraining device should be used to eliminate undue strain on the flex hose -For installation on combustible floors (with 6” high legs) and adjacent to combustible walls, allow 6” clearance. -Install under vented hood -Check local codes for fire, installation and sanitary regulations. NOTICE: Southbend has a policy of continuous product research and improvement. We reserve the right to change specifications and product design without notice. Such revisions do not entitle the buyer to corresponding changes, improvements, additions or replacements for previously purchased equipment. GAS: -460DD-3G/T Total BTU NAT: 286,000; LP: 264,000 -460AD-3G/T Total BTU NAT: 273,000; LP: 254,000 -460AA-3G/T Total BTU NAT: 260,000; LP: 244,000 -460DD-4G/T Total BTU NAT: 236,000; LP: 220,000 -460AD-4G/T Total BTU NAT: 223,000; LP: 210,000 -460AA-4G/T Total BTU NAT: 210,000; LP: 200,000 -Required minimum inlet pressure -Natural gas 4” W.C. -Propane gas 10” W.C. -Pressure regulator is supply with unit -Required supply line size to the regulator is 3/4” NPT. ELECTRICAL: -Standard -115/60/1 furnished with 6’ cord with 3-prong plug. Total max amps 4.8 -Optional -208/60/1, 50/60/1 or 3 phase. Supply must be wired to junction box with terminal block located at rear. Total max amps 2.6 MODELS EXTERIOR ...
Other models in this manual:Electric Ovens - 460AD-3G (667.61 kb)
Electric Ovens - 460AA-3G (667.61 kb)
Electric Ovens - 460AA-4G (667.61 kb)
Electric Ovens - 460AD-3G (667.61 kb)