The shredding of other metal items may damage the shredder. Plastic materials such as charge cards, covers, inserts, and film may be shredded occasionally, however, extended shredding of such materials will prematurely dull the cutters. The shredder control panel is shown in Figure 4.0.1. To start shredding, press the white "ON" push button and feed the paper to be shredded into the throat of the shredder. Never exceed the maximum capacity of the shredder. To turn the shredder off press the red

Read the corresponding PROBABLE MALFUNCTION, and then preform the recommended procedure in the CORRECTIVE ACTION column. When replacing electrical components having push on type terminals, tag the electrical leads that are removed to facilitate reconnecting them. Refer to the wiring diagram in figure 5.5 to resolve any wiring difficulties that may occur. Warning: Always unplug the shredder to avoid possible severe electrical shocks before attempting to preform any repair. 9 5.3 TROUBLESHOOTIN

LISEZ-LES TRES ATTENTIVEMENT. LE SYMBOLE D’ALERTE DE SECURITE PRECEDE CHAQUE MESSAGE DU MANUEL DE L’OPERATEUR RELATIF A LA SECURITE. CE SYMBOLE INDIQUE UN RISQUE POSSIBLE DE BLESSURES CORPORELLES POUR L’UTILISATEUR OU D’EVENTUELS DOMMAGES POUR L’EQUIPEMENT. LISEZ-LES TRES ATTENTIVEMENT. GARDEZ CES CONSIGNES POUR UTILISATION ULTERIEURE. LES AVERTISSEMENTS SUIVANTS SE TROUVENT SUR CE MODELE. CE MESSAGE DE SECURITE INDIQUE UN RISQUE DE BLESSURES SERIEUSES VOIRE LA MORT SI VOUS OUVREZ LA PLASTIFIEUS

First, pull out the waste receptacle (1) and remove the red round belt (2). Turn over the top of the bag several times (3), insert the plastic bag in the waste receptacle and fasten with the round belt (4). Push the waste receptacle into the cabinet and close the cabinet door (5). 05 FIGURE 3 On/Forward Reverse Bin Full Door Ajar Off On Light FIGURE 4 F E D OPERATION POWER ON FIGURE 3. Press the button to Power On. The green light will illuminate when ready to operate. You are now ready to shred

This current path keeps the relay activated when the "ON" push button of the main control switch is released. The second current path is from the hot leg to the neutral leg of the circuit, through two parallel circuits. The first circuit is through the run coil of the motor (Ml), the second is through the main control switch (S3), starting capacitor (Cl), start coil of the motor (Ml). 3. Reverse (S2). The reverse switch is in series with the the coil of the relay. When this switch is activated