Votes - 2, Average rating: 4
(
)
)
|
manual abstract
(1-800-626-5771) or visit TABLE OF CONTENT 1 Faucet 2 Flexible hose of the side spray 3 Hook for side spray 4 Side spray 5 Priority water flow system 6 Fastening set (rubber washer, metal washer, nut) 7 Fastening set (rubber washer, triangular flange, metal washer, nut, allen key 2,5mm) 8 Counter weight 3 ENGLISH Install faucet to the sink or countertop Set the faucet into place on the sink as indicated in the figure. NOTE: the rubber O-ring should be sitting on top of the countertop and between the faucet body. DO NOT use putty or other sealant at this location. 4 ENGLISH Install faucet to the sink or countertop - follows 7 Install the fastening components to the faucet’s threaded shank in the following sequence: round gasket (1), triangular flange (2), metal washer (3) and threaded nut (4) (the triangular flange can be omitted if the sink/countertop is too thick). Install the fastening items of the spray head holder in the following sequence: the flat rubber washer (5), the metal washer (6) and the threaded nut (7). 5 ENGLISH Assembly of side spray and connecting of the priority water flow system ' ' Proceed to the connection of the flexible hose of the side spray (A) and the priority water flow system (B - follow the phases indicated). Interposing the holding gaskets within the connections as indicated in the figure. Fix the lead counter weight to the flexible hose of the side spray at a distance of approx. 40 cm from the connection to the outlet pipe. 6 ENGLISH Connect the supply lines Connect the hot and cold supply lines. Do not allow the supply tubes to twist or bend sharply. Leave the valves closed. - Move the faucet handle by rotating it onwards so that it opens in the full hot position and open the hot supply for 15 seconds. Close the hot supply. - Move the faucet handle by rotating it backwards so that it opens in the full cold position and open the cold supply for 15 seconds. Close the cold supply. - Move the faucet handle to the off position. 7 ENGLISH Replacing the cartridge Before starting, shut off the water supply to the faucet and move the faucet handle to the off position. Use a 2.5 mm Allen key to loosen the set screw (A) which is accessible from the back of the handle. Lift the handle (B) from the cartridge (F). Find the small notch at the base of the chrome ring cap and carefully pry up against this to remove the cap (C). Remove the brass retaining ring (E) using a 28 mm wrench. Lift out the cartridge (F). Ensure that the grommets (O-rings) are in good condition and properly seated and remove all mineral deposits. Install the new cartridge so that the central pivots fit into the corresponding seats. 8 ENGLISH Cleaning of the aerator It is recommended that you periodically clean the aerator of your faucet. To do so, unscrew the aerator holder from its own seat. Simply using a toothbrush, or something similar, rub the filter under the water, removing the impurities and any build up. Screw the areator back into place. Cleaning of the side spray Any deposits which may accumulate on the nozzle can be removed by simply running a finger over the rubber extrusions and then running the water for a few seconds. In extreme cases this step may have to be repeated. 9 ENGLISH General maintenance Clean aerator periodically. Do not use harsh detergents, solvents, chemical agents, metallic sponges, etc. that could harm the surface. Clean only with a soft sponge and soapy water. Clean and then dry properly the faucet in case of very hard or calcareous water, whose deposits cold damage the surface. 10 ENGLISH Limited lifetime warranty Franke Consumer Products, Inc., Kitchen Systems Division extends the following warranty to the original purchaser of its faucets effective January 1, 2003. All faucets installed in a private residence will carry a limited lifetime warranty on all mechanical parts to be free of manufacturing defects in material and workmanship under normal usage. All chrome finishes carry a limited lifetime warranty; all other finishes are warranted for five (5) years form the original date of purchase. Marine and Outdoor Installation: Franke Consumer Products, Inc. faucets are NOT warranted for Marine and Outdoor installations. This warranty applies only to the original owner, providing the product has been installed in accordance with our installation instructions, used as recommended and in a normal residential application. In the event of a warranty claim, the owner will be required to provide proof of purchase - save sales receipt. This warranty covers all components which make the product operational. Franke, at its option, may repair or replace the product or components necessary to restore the product to good working condition. Franke reserves the right to inspect the installation prior to the actual replacement of the product or component part. This warranty does not cover misuse or abuse, accidental damag...