Votes - 3, Average rating: 3.7 ( )

Manafacture: Techno Source File size: 2.67 mb File name: Language of manual:

You cannot reuse the code for multiple accounts. * If you have purchased a Refill Pack, you can log-in to your previously created Printies™ account and start designing! PRINT YOUR CREATION IMPORTANT: Printies™ Fabric sheets should only be used with inkjet printers and never with a laser printer or commercial copier. After you have finished designing your Printies™ character online, follow the on-screen instructions. Use Printies™ Test sheets to make sure your printed design looks the way you want and prints out correctly. Pay close attention to the side and direction your design prints out on. 1. When you are satisfied with the test sheet print outs, load the Printies™ Fabric sheet into the printer tray on the appropriate side and print the front side. 2. Allow the ink to completely dry (approximately 5 minutes). 3. Print the back side of the Printies™ Fabric sheet and let the ink dry for an additional 5 minutes before proceeding to tear it out from the sheet. Note: Both Mini-Printies designs must be printed out at the same time. If you print and pop-out only one of the Mini-Printies, you will not be able to use your sheet again to print out the other. TIPS: * To save ink, set your printing parameters to “Fast” or “Draft” when printing onto your Printies™ Test sheets. * For more vibrant colors, set your printing parameters to “Best”, “High”, or “Fine” when printing your design onto the Printies™ Fabric sheets. STUFF AND SHOW OFF! After you have printed both sides of the sheet, you are now ready to bring your Printies™ character to life! 1. Start by tearing the paper off by following the perforated lines from the edges of the paper. Pop out your Printies™ character by holding the character in one hand (hold it close to the edge of the fabric) and slowly pulling the paper with your other hand. (Fig. 1) Gently peel the stuffing tab off the paper. Stuff your Printies™ character by using the stuffing tool and inserting small amounts of stuffing material into the stuffing hole. Each stuffing sleeve contains enough material for one regular size Printies™ character or two mini-Printies™ characters. Printies™ should only be stuffed with the stuffing material provided in the pack. Use this end to move and adjust the stuffing, especially in narrow areas. Use this end to push stuffing to the sides or to scoop < 3. 4. 5. 6. 7. Fig. 2 Tuck the stuffing tab into the stuffing hole once the Printies™ character is stuffed. (Fig. 2) Time to accessorize! Open the shoes/stand by using your finger to gently pull the plastic tab located on the side of the shoe. Place the open shoe on a table and position the stuffed Printies™ character so the bottom touches the table. Close and snap the shoe shut to lock it in. For a better fit and centered stuffed toy, pull the fabric under the shoes to adjust as necessary. Shoes should not be removed once placed on your Printies™ character. Decorate your shoes/stand by choosing from the sticker sheet. Thin...

Download now

Please, enter two numbers from picture: