Votes - 4, Average rating: 4 ( )

Manafacture: Bolens File size: 577.9 kb File name: Language of manual:

If these items cannot be obtained locally, order by part number and size as shown on the Parts List. „coo -a f Part of throttle control complete. 310-10029 on (110-120-306 and 110-140-306) JPart of wheel adjustment assembly, 310-9691 L.H. (Complete) and 310-9692 R.H. fpart contro] complete 310_io033 on (110-121-306 and 110-141-306) ASSEMBLY FOR MODELS 110-120 AND 110-140. Your new mower is shipped completely assembled with the exception of the handle. 1. Remove lawn mower and all parts from carton. Make certain that all loose parts and literature are removed from carton before carton is discarded. 2. Extend throttle control assembly, which is attached to rear of mower and place on floor. CAUTION: Do not bend or kink control wire. 3. A. Snap lower handle into position on two lugs which extend from either side on the rear of the deck. B. Assemble the two upper handle parts with cap screws and locknuts provided in parts bag. The yellow cap screw should be used to attach throttle control assembly to upper handle as shown in diagram. Do not tighten nuts. C. Attach upper handle assembly to lower handle with cap screws and locknuts. Tighten all nuts. D. Secure control wire to lower handle with cable clips. E. Place the plastic control cover over the throttle control and secure with two self-tapping screws. 4. Check blade bolts for proper tightness. OPERATION NOTE: For shipping purposes your mower is set with the wheels in a low cutting height position. For best results raise the cutting position until it is determined which height is best for your lawn. See adjustments. 1. Service engine with gas and oil. See Engine Manual packed with lawn mower for complete instructions for the care and maintenance of engine. Read Directions Carefully. 2. When ready to start engine, place throttle control lever, on handle, in “START” position and start engine in accordance with instructions in Engine Manual. After engine starts, move throttle control lever, on handle, to desired engine speed. The engine is stopped by placing control lever on handle in the “STOP” position. 3. Be sure that lawn is clear of stones, sticks, wire or other objects which could damage lawn mower or engine. For best results and to insure more even grass distribution, do not mow when lawn is excessively wet. ADJUSTMENTS CAUTION: Do not at any time make any adjustment to lawn mower without first stopping engine and disconnecting spatk plug wire. EASY CUTTING HEIGHT—FOR MODELS 110-121 and 141—An adjusting plate and thumb lever at each wheel position provides cutting- height adjustment. Each adjusting plate has five holes. Height of cut will be changed when the thumb lever is moved from one hole to another. Simply depress thumb lever towards wheel and move wheel and lever assembly to desired position. Cutting height will be raised as lever is moved toward front and lowered as lever is moved toward rear. All wheels must be positioned in relative height of cut positions. STANDARD CUTTING HEIGHT—FOR MODELS 110-120 and 110-140—Adjustment may be made by removing and moving wheel studs to desired position. Cutting heights will be raised as wheel studs are moved to a lower hole and lowered as wheel studs are moved to a higher hole in the deck. All wheel studs must be mounted in a relative position to t...

Download now

Please, enter two numbers from picture: