Votes - 2, Average rating: 4.5
(
)
)
|
manual abstract
If the results of your work with the Lawn Scarifier become increasingly worse due to wear of the spring tines, the aerator cylinder can be adjusted twice. The aerator cylinder has 4 adjustment positions: • Transport position • Aerating position 1 : • Aerating position 2 : If the springs are worn (the scarifier roller is lowered by 3 mm). • Setting 3 : Second setting for worn springs (the scarifier roller is lowered by a further 3 mm). Push wear compensation lever D gently away from the housing and move to the position required. Note:Wear adjustment is not used for height adjustment. Adjustment of the aerator cylinder without visible wear can cause damage to the aerator cylinder or overload the motor. 15 7. Trouble-Shooting GB Replacing spring tines: EFGHIJ LKJ Danger! The aerator cylinder can cause injuries ! AV Prior to rectifying faults, unplug from the mains and wait until the aerator cylinder has stopped. V Wear working gloves when rectifying faults. If the aerator cylinder is not yet worn but individual springs have broken, these must be replaced. Only original GARDENA replacement springs may be used. • Replacement spring tines for Electric Aerator GARDENA ES 500 Art. 4094 1. Unscrew two screws E on the underside of the housing. 2. Lift aerator cylinder F at an angle 1 and pull away the drive shaft 2. 3. Pull bearing shell G off the aerator cylinder F. 4. Unscrew and remove screw H and draw out bearing bolt I. 5. Remove cover plate J and spring elements K from the spring element holder L. 6. Push new spring elements K and cover plate J on the spring element holder L. The bores on the cover plateJ and the spring element holder L must lie on top of each other. 7. Push in bearing bolt I in such a way that all 3 bores (bearing bolt I, cover plate J and spring element holder L) are on top of each other. 8. Screw in screw H. 9. Push aerator cylinder F on to the drive shaft. 10. Put bearing shell G on the aerator cylinder F. 11. Screw bearing shell G on to the lower side of the housing with the screw E without tightening too much. Problem Possible Cause Remedy Abnormal noise. Clattering in the unit Whistling sound Foreign bodies on the aerator cylinder are hitting the Aerator. Foreign bodies blocking the aerator cylinder. 1. Switch off the scarifier, remove the mains plug from the socket and wait until the cylinder has stopped rotating. 2. Remove foreign bodies. 3. Check Scarifier immediately. 16 Problem Possible Cause Remedy Whistling sound Cogged belt slipping. v Contact GARDENA Service. Motor will not start Faulty cable. v Check cable. The conductor cross-section of v Contact your electrician. the extension cable is possibly too low. Motor cuts out because Blocked by foreign bodies. 1. Switch off the motor, re- blocking protection has move the mains plug from been activated the socket and wait until the Scarifier has stopped rotating. 2. Remove foreign bodies. 3. After approx. 1 minute switch on the Scarifier. GB Aerating depth too large (aerato...
Other models in this manual:Lawn Mowers - ES 500 (547.12 kb)
Lawn Mowers - ES 500 (547.12 kb)
Lawn Mowers - ES 500 (547.12 kb)
Lawn Mowers - ES 500 (547.12 kb)