Votes - 2, Average rating: 3.5 ( )

Manafacture: Flymo File size: 2.13 mb File name: OOEN2009_505485402.pdf Language of manual:

Never cut grass by pulling the mower towards you. R.C.D. every time you use it. 10. Switch off before pushing the mower over surfaces 2. Before use, examine cable for damage, replace it ifother than grass. there are signs of damage or ageing. 11. Never operate the lawnmower with damaged guards or 3. Do not use the lawnmower if the electric cables are without guards in place. damaged or worn 12. Keep hands and feet away from the blade at all times and es4. Immediately disconnect from the mains electricity supply ifpecially when switching on the motor. the cable is cut, or the insulation is damaged. Do not touch 13. Do not tilt lawnmower when the motor is running, except whenthe electric cable until the electrical supply has been dis-starting and stopping. In this case, do not tilt more than ab- connected. Do not repair a cut or damaged cable. Re-solutely necessary and lift only the part which is away from theplace it with a new one. operator. Always ensure that both hands are in the operating 5. Your extension cable must be uncoiled, coiled cables canposition before returning the appliance to the ground. overheat and reduce the efficiency of your mower. 14. Do not put hands near the grass discharge chute. 6. Keep cable away from lawnmower, always work away from the15. Never pick up or carry a mower when it is operating orpower point mowing up and down, never in circles. still connected to the mains supply. 7. Do not pull cable around sharp objects. 16. Remove the plug from the mains : 8. Always switch off at the mains before disconnecting any-before leaving the mower unattended for any period; plug, cable connector or extension cable. -before clearing a blockage; 9. Switch off, remove plug from mains and examine elec--before checking, cleaning or working on the appliance; tric supply cable for damage or ageing before winding -if you hit an object. Do not use your lawnmower untilcable for storage. Do not repair a damaged cable, re-you are sure that the entire lawnmower is in a safe operplace it with a new one. Use only Flymo replacement ating condition.; cable. -if the lawnmower starts to vibrate abnormally. Check imme10. Always wind cable carefully, avoiding kinking.diately. Excessive vibration can cause injury. 11. Never carry the product by the cable.Maintenance and storage 12. Never pull on the cable to disconnect any of the plugs.1. Caution: Do not touch rotating blade(s) 13. Use only on AC mains supply voltage shown on the 2. Keep all nuts, bolts and screws tight to be sure theproduct rating label.lawnmower is in safe working condition. 14. Flymo Products are double insulated to EN60335. 3. Check the grassbox frequently for wear or deterioration. Under no circumstance should an earth be connected 4. Replace worn or damaged parts for safety. to any part of the product.5. Only use the replacement blade, blade bolt, spacer and Preparation impeller specified for this product. 1. While using your product always wear substantial6. Be careful during adjustment of the lawnmower to pre- footwear and long trousers. vent entrapment of the fingers between moving blades 2. Make sure the lawn is clear of sticks, stones, bones, wireand fixed parts of the machine. and debris; they could be thrown by the blade. 7. Store in a cool dry place and out of reach of 3. Before using the machine and after any impact, check forchildren. Do not store outdoors. signs of wear or damage and repair as necessary. 8. Allow the product to cool for atleast 30 minutes before storing. 4. Replace worn or damaged blades together with their CABLES - IMPORTANT 1. No earth required. Flymo products are double insu • Use only 1.00mm2 size cable up to 40 metres length lated to EN60335 and under no circumstances should maximum. an earth be connected to any part of the product. Maximum rating :2. Ensure the mains voltage suits your product 1.00mm2 size cable, 10 amps 250 volts AC.3. IMPORTANT! •YOUR PRODUCT IS SUPPLIED WITH CABLE WIRED The wires in the mains lead are coloured in accor- DIRECTLY INTO THE PRODUCT. dance with the following code: 1. Flymo Mains Cables and Extension Cables are available BLUE -NEUTRAL from your local Approved Service Centre.BROWN -LIVE 2. Do not wire an extension cable directly to your product The wire which is coloured BLUE must be connected yourself. Please contact your local Approved Serviceto the Terminal which is marked with the letter 'N' or Centre for further information on the connectors and coloured BLACK. kits available. The wire which is coloured BROWN must be con3. Only use extension cables specifically designed fornected to the Terminal which is marked with the letter outdoor use. 'L' or coloured RED. CONNECTORS - IMPORTANT 4. It is important that the outer sheath is clamped cor • Flymo connectors are suitable for use with 2 corerectly into the 3-pin plug. cable only. Under no circumstances should these con-5. If in doubt consult your local Service Repairer or qualinectors be used for earthed products. fied el...

Download now

Please, enter two numbers from picture: