'JCL’I. CAUTION: The break-away power cord is for accidental disconnection. Do not remove during normal operation. If the cord becomes disconnected, immediately remove the plug (10) from the wall outlet. Turn temperature control knob (12) to • OFF, then reconnect the magnetic plug (19) to the deep fryer. Then reconnect the plug (10) to the wall outlet. WARNING: This appliance generates heat and steam during use. Proper precautions must be taken to prevent the risk of burns, fires, or other inj

The lamp (LT) will continue to flash until the nominal cookingtemperature is reached. It then stays on permanently. When illuminated, this lamp (LV) indicates that steam condensation is switched on. When cooking is completed, steam condensation will start automatically and will remain in operationuntil the pressure in the appliance has been reduced to normal. The lamp (LV) will flash during the cooling phase. 4.4 Shutting down An acoustic signal sounds when cooking is over. This is acknowledged

Page 10 62.9696.01 OPERATING INSTRUCTIONS T Temperature in food S Start E End Z Time ZG Total cooking time ZS Rise time ZH Holding time ZF Fall-off time Fig. 10 Cooking times 7.4 Some cooking instructions 7.4.1 Meat In all methods for preparing meat together with a sauce, forexample pot roasts, goulash, stews, various jugged meats, braised beef, etc., the meat must first be individually browned, i.e. roasted without pressure. The meat is then cooked with thesauce in the same appliance under pres

Start again by pressing the a2 Malfunction at burner igni- button (TT). Consider the tion delay time of 30 to 60 sec- onds. ing sand, etc. as such media destroy the surfaces and create the conditions for corrosion formation. Spraying appliances or parts of appliances with a water jet or high pressure cleaning equipment is harmful and can cause malfunction. This is therefore prohibited. Note: The type and concentration of solvents used for cleaning the surfaces must comply with the code of th

Electrical Power If electric circuit is overloaded with other appliances, skillet may not operate properly. Skillet must be operated on separate circuit from other operating appliances. Tempered Glass Lid Lid Handle Steam Vent Handles/Legs Temperature Control Probe* Parts and Features 1 2 3 4 5 Polarized Plug This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug is intended to fit into a polarized outlet only one way. If plug doe

To read more about GE's ecomagination commitment, visit: ge.ecomagination.com Barcode: 690 5033 11 000 00211 Client: Jarden (Wal*Mart) Project: 169170 Language: EN Date: 12.12.2007 Version: 05 Page: (of 9 pages) IMPORTANT SAFEGUARDS When using electrical appliances, basic safety precautions should always be followed, including the following: 1. Read all instructions before using. 2. Do not touch hot surfaces. Use handles or knobs. 3. To protect against electrical shock, do not immerse temperatur

THIS INFORMATION SHALL BE OBTAINED BY CONSULTING YOUR LOCAL GAS SUPPLIER. THE APPLIANCE AND ITS INDIVIDUAL SHUT OFF VALVE MUST BE DISCONNECTED FROM THE GAS SUPPLY PIPING SYSTEM DURING ANY PRESSURE TESTING OF THAT SYSTEM ATTEST PRESSURES IN EXCESS OF 1/2 PSIG. (3.45 KPA). THE APPLIANCE MUST BE ISOLATED FROM THE GAS SUPPLY PIPING SYSTEM BY CLOSING ITS INDIVIDUAL MANUAL SHUT OFF VALVE DURING ANY PRESSURE TESTING OF THE GAS SUPPLY PIPING SYSTEM AT TEST PRESSURES EQUAL TO OR LESS THAN 1/2 PSIG. (3.

This applies especially to safety and control elements. Parts requiring replacement are only to be replaced by original spare parts. A service contract is recommended. ▲ Cleaning and maintenance must be done only when the heating surfaces are cold. Do not use inflammable liquids to clean the appliance. ▲ An obligatory service check is required annually. 2. TECHNICAL DATA PNC Appliances Appliance type Voltage Width Depth Height Trough contents Power V inch mm in kW 9CHG584093 WFWROFOOOO