Votes - 1, Average rating: 3
(
)
)
|
manual abstract
Read all instructions for use carefully and look at the illustrations before you start using the appliance. 2. Do not touch hot surfaces, always use handles or knobs. 3. To protect against electrical shock, do not immerse cord, plug or the thermostat control probe of this appliance in water or other liquids. 4. Close supervision is necessary when any appliance is used by or near children. 5. Unplug from outlet when not in use and before cleaning. Allow the unit to cool before putting on or taking off parts and before cleaning the appliance. 6. Do not operate any appliance with a damaged cord or plug, or after the appliance malfunctions, has been dropped or damaged in any manner. Return the appliance to EURO-PRO Operating LLC for examination, repair or adjustment. See warranty. 7. The use of accessory attachments not recommended by the appliance manufacturer may cause fire, electric shock or injuries. 8. Do not use outdoors. 9. Do not let cord hang over the edge of the table, counter or touch hot surfaces. 10. Do not place on or near a hot gas or electric burner, or in a heated oven. 11. Extreme caution must be used when moving any appliance containing hot oil or other hot liquids. 12. Always insert thermostat control probe into the unit first and then plug into the wall outlet. To disconnect, turn the thermostat control probe “Off” first, then remove plug from wall outlet then wait for the unit to cool completelybefore removing the thermostat control probe from the unit. 13. Do not leave appliance unattended while in use. 14. Do not use appliance for other than intended household use. 15. Always place the appliance on a flat, dry, heat resistant surface when using. GETTING TO KNOW YOUR ELECTRIC SKILLET SPECIAL SAFETY INSTRUCTIONS • This appliance has a short cord to reduce hazards of becoming entangled or tripping over a longer cord. An extension cord may be used if the electrical rating of the extension cord is equal to or greater than the rating of the electric grill. Use only an extension cord rated 15 amperes or greater. Care must be taken to arrange the extension cord so that it will not drape over countertop or tabletop where it can be pulled on by children or tripped over. • Do not immerse the thermostat control probe and plug in water or any other liquid. • When opening the lid after frying, lift it slowly and wait a moment to allowthe steam inside to escape before opening fully. • To avoid a circuit overload, do not operate another high wattage appliance on the same circuit. GROUNDED-TYPE 3-WIRE PLUG WARNING: this appliance is equipped with a grounded-type 3- wire cord ( 3-prongplug). This type of plug will only fit into an electrical outlet made for a 3-prong plug. This is a safety feature intended to help reduce the risk of electrical shock. If the plug should fail to fit, contact a qualified electrician to replace the obsolete outlet. Do NOT attempt to defeat the safety purpose of the grounding pin bymodifying the plug in any way. SAVE THESE FOR HOUSEHOLD Rev. 07/04B 1 1. Glass Lid Handle 7. Temperature Ready Light 2. Glass Lid 8. Thermostat Control Probe 3. Steam Vent 9. Thermostat Control Probe 4. Non- stick Surface Receptacle 5. Skillet Handles 10. Non- skid Feet 6. Temperature Control 11. Heating Element Base Knob 12. 3- Prong Plug Illustrations may differ from actual product. Technical Specifications Voltage: 120V., 60Hz. Power: 1500 Watts 2 OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS Read all the sections of this booklet and follow all the instructions carefully. Using for the First Time Before using the skillet for the first time, wash, rinse and dry the skillet and the glass lid in warm, soapy water. Dry completely. CAUTION: NEVER immerse the thermostat control probe and plug inwater or any other liquid. Note: Prior to first use, if desired, apply a thin coat of cooking oil onto the non-stick coating on the inside of the skillet. Remove any excess oil with a cloth or paper towel. This unit should not be used to boil water. Using Your Electric Skillet 1. Place the skillet on a flat, dry, heat resistant surface. 2. Insert the thermostat control probe into the thermostat control prove receptacle. 3. Plug the 3-prong plug into the electrical outlet and set the temperature control knob to the desired temperature. Always plug the cord into the skillet first, then into the electrical wall outlet. 4. The temperature ready light will come on when you set or adjust the temperature. Once the desired temperature is reached, the temperature ready light will go out. During cooking, the temperature ready light will go on and off indicating that the surface temperature is being maintained. Important : The temperature control is a sensitive device; use care not to drop, hit or impact the temperature control against hard surfaces, as it could affect the temperature calibration. Do not use the temperature control if it overheats or is damaged in any other way...