Votes - 3, Average rating: 3.7 ( )

Manafacture: Heath Zenith File size: 535.6 kb File name: 598-1142-01.pdf Language of manual:

Manual Storage Slot: A convenient slot in the base has been provided to insert the manual for future reference. Volume Control: Turn the volume control clockwise to increase the volume or counterclockwise to decrease the volume. Reset Button: This button has a dual purpose. 1) To return to the first tune in a Group when using the Tune Selection Button to cycle through the tune selections. 2) To reset the chime in case of power failure or surge. Cover Pin: A notched cover pin is located on two sides of the chime base. These pins are for selected covers which hang on the base. Tune Selections: There are 63 tunes (divided into 9 groups of 7) available for the front door and 2 tunes available for the rear door. The Tune Selection Guidecan be found on page 28. IMPORTANT INSTALLATION NOTES •A diode connected to the front door pushbutton is required for this chime to operate. The enclosed pushbutton has a diode factory installed to be used for the front door connection. Note:An additional diode is enclosed for use with other pushbuttons. See page 5 for installation instructions. • This chime must have a front door pushbutton with diode connected to operate properly. IMPORTANT: The chime will operate with a front door connection only. The chime will not operate properly with just a rear door pushbutton installed. © 2003 DESA Specialty Products™ 598-1142-01 RESET SCROLL TUNESELECTION REARTUNE 12 12 3 4 5 6 7 8 9 OFF GROUP SELECTION 74 BASE Screw/Tornillo/Vis Wire Entrance Hole/Orificio de entrada del cable/Orifice d’entree des fils Manual Holder/ Portamanual/ Porte-guide Cover Pins/Sujetadores de la tapa/Agrafes de couvercle Mounting Hole/ Orificio de montaje/ Orifice d’installation Wall Anchor (If Needed)/Anclas de pared (Si es necesario)/ Ancrage mural (au besoin) RESET SCROLL TUNESELECTION REARTUNE 12 12 3 4 5 6 7 8 9 OFF GROUP SELECTION 74 BASE Screw/Tornillo/Vis Wire Entrance Hole/Orificio de entrada del cable/Orifice d’entree des fils Manual Holder/ Portamanual/ Porte-guide Cover Pins/Sujetadores de la tapa/Agrafes de couvercle Mounting Hole/ Orificio de montaje/ Orifice d’installation Wall Anchor (If Needed)/Anclas de pared (Si es necesario)/ Ancrage mural (au besoin) Mounting Orientation Marking/ Marca para la orientacion del montaje/Marques du sens du montage Wire Entrance Hole/Orificio de entrada del cable/Orifice UP d’entree des fils Front Push Button with Diode/Pulsador delantero con diodo/Bouton-poussoir d’entree principale avec diode Wire Nut/Tuerca de cable/Ecrou pour fil Figure/Figura 1 Mounting Orientation Marking/Marca para la orientacion del montaje/Marques du sens du montage Manual Holder/Portamanual/Porte-guide Chime/Campana/Carillon FRONT TRANS REAR Rear Push Button (If Applicable)/ Pulsador posterior (Si esR aplicable)/Bouton-poussoir d’entree secondaire (au besoin) FT Note: Use wire tags on packaging./Nota: Use los identificadores de alambre del paquete./Note :Utilisez les etiquettes de fil Transformer/Transformador/Transformateur de l’emballage. Figure/Figura 2 2 598-1142-01 Group Selection/Seleccion del grupo/ Selecteur de groupe RESET SCROLL TUNESELECTION REARTUNE 12 12 3 4 5 6 7 8 9 OFF GROUP SELECTION 74 BASE Reset Button/Boton de restauracion/Bouton de reinitialisation Tune Selection Button/Boton selector del tono/Bouton de selection d’air Tune Selector/Selector del tono/Selecteur d’air Note:No tune will play when Group Selection is in the “OFF” position. Nota:No se escuchara ningun tono si la perilla Seleccion del Grupo esta en la posicion “OFF”. Note :Le carillon ne joue aucun air lorsque le selecteur de groupe est en position « OFF ». Rear Tune Selector/Selector del tono posterior/Selecteur d’air pour l’entree secondaire Volume Control/Control de volumen/ Commande du volume Figure/Figura 3 Note:The Tune Selection Guidecan be found on page 28. Nota:La Guia de seleccion de tonosesta en la pagina 26. Note :Le Guide de selection des airs se trouvea la page 27. 598-1142-01 3 MOUNTING SUGGESTIONS • Power must be supplied from a 16 Volt, 10 Watt transformer or 16 Volt, 15 Watt transformer (Heath®/ Zenith models 122C, 121AC, or 125C). • Mount door chime in a central location so it can be heard throughout the home (for new installations). • See actual unit for orientation of base (see Figure 1). • Always use mounting wall anchors. • Use all mounting holes located at four corners of base. • Route the wires through the wire entrance hole (see Figure 1). NEW INSTALLATION WIRING WARNING: Turn power off at fuse or circuit breaker before installing transformer. Follow all national and local codes. 1. Mount Transformer: Transformers should be mounted on or near a junction box. They can also be mounted to the electrical service panels. Junction boxes in utility rooms, crawl spaces, or basements are preferred. Avoid attic locations. 2. Install 16 Volt, 10 Watt transformer according to the instructions supplied with transformer. 3. Run two No. 20 AWG or better bell wires (Heath®/Zenith No. 196C or No. ...

Download now

Please, enter two numbers from picture: