Votes - 3, Average rating: 3.7 ( )

Manafacture: Lennox Hearth File size: 227.78 kb File name: Language of manual:

Instruction Sheet Table 2 Arch Screen Panel TOOLS REQUIRED None GENERAL INFORMATION This one-piece decorative screen panel assembly fits on the face of the appliance over the glass doorframe. If you encounter any problems, need clarification of these instructions or are not qualified to properly install this kit, contact you local distributor or dealer. Read and understand all instructions and warnings in this document before beginning the installation. CAUTION INSTALL ONLY WHEN THE FIREPLACE IS OFF AND COLD! WARNINGS Hot! Do not touch! These decorative screen doors are NOT heat guards. The tempered glass behind the screens will be hot during operation and will retain heat for a while after shutting off the appliance. Severe burns may result. Carefully supervise children in the same room as appliance. • As with any similar heating appliance, surfaces of the frame, the door and appliance can become very hot. INSTALLATION INSTRUCTIONS: 1. Remove Top Panel - Remove the top louvered or radiant panel/hood assembly by pulling the assembly up and out (see Figure 1). In instances where the radiant panel is used and it is framed in with tile or other approved material, the hood must still be removed by firmly pulling it forward until it releases from the receiving brackets. Some models have bustles (as shown in Figure 2) which must be removed. If applicable, remove the top and bottom bustle by lifting them up and out. Top Panel Removed Trim Panels will be either Louvered Panels or Radiant Panels. Radiant Panels Louvered Panels Figure 1 -Remove Top Panel NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. Bustles Figure 2 - Remove Bustles Lift Bustles Up And Off Only Some Models Have Bustles Bustles Figure 2 - Remove Bustles Lift Bustles Up And Off Only Some Models Have Bustles 2. Ensure the glass door assembly on the fireplace is properly aligned as follows: a. Open or remove lower compartment door (refer to Homeowner’s Manual provided with appliance). Note: Units with Modesty Panels - Remove the modesty panel as follows: Lift the modesty panel by the tab on the panel’s right end, pull the right end of the panel away from cabinet and then pull the panel diagonally out of the corner post slots on the left side of the unit. Remove the modesty panel carefully, so that none of the wires become loose or disconnected. b. Open the latch(es) at the bottom of the glass door assembly as shown in Figure 3 (refer to Homeowners Manual). c. Adjust glass door so that it is evenly spaced and aligned to the fi replace chassis on both sides. See Figure 3. d. Fasten the latch(es). Ensure that the latch(es) are engaged with the door’s vee-fl ange and fully closed. See Figure 3. Figure 3 -GLASS DOOR ADJUSTMENT Top Flange on Glass Door Bottom Vee-fl ange Glass Door Glass Door Latch Glass Door Firebox Floor Some models will have a modesty panel in the control compartment (in front of the valve). The appearance will vary from the example shown below. Modesty Panel Install Top of Do...

Download now

Please, enter two numbers from picture: