Votes - 0, Average rating: 0
(
)
)
|
manual abstract
Symptom Remedy No power • Check if both plugs of the mains cord are properly connected. • Check if there is power at the AC outlet by plugging in another appliance. • Check if car adaptor is connected appropriately. Distorted picture • Check the disc for fingerprints and clean with a soft cloth, wiping from centre to edge. • Sometimes a small amount of picture distortion may appear. This is not a malfunction. Completely distorted picture / no colour in the TV screen The NTSC/PAL setting may be in the wrong status. Match your TV’s setting with the player’s setting. No sound Check audio connections. If using a HiFi amplifier, try another sound source. Disc can’t be played • Ensure the disc label is upwards. • Clean the disc. • Check if the disc is defective by trying another disc. Do not load any 8-cm mini DVD discs into the player. The DVD player does not play mini DVD discs. If the disc gets stuck inside the player, press 9 / twice to eject the disc. Try the following steps if the disc remains stuck inside the player. 1 Power off and then power on the player. Press 9 / to eject the disc. 2 If this does not work, hold the player with the slot facing down, gently shake the player until the disc comes out. The player does not respond to the remote control Aim the remote control directly at the sensor on the front of the player. Avoid all obstacles that may interfere with the signal path. Inspect or replace the batteries. Distorted or B/W picture with DVD Use only discs formatted according to the TV-set used (PAL/NTSC). No audio at digital output • Check the digital connections. Loss of current TV programs when travelling to another country 1 Press SETUP > TV/RADIO > Country 2 Select your country 3 Select Auto search Player does not respond to all operating commands during playback • Operations are not permitted by the disc. • Refer to the instructions in the disc inlay. Player feels warm When the player is in use for a long period of time, the surface will be heated. This is normal. Display goes dimmer when AC is unplugged The unit is saving power to ensure longer playtime with battery. It is normal. Adjust the brightness in the SETUP men What can be the problem when I have no radio receptions? This unit is designed to receive digital radio signals only and it does not support analog radio such as FM or AM. Cannot charge the player Check if both plugs of the mains cord are properly connected. Check if there is power at the AC outlet by plugging in another appliance. Check if car adaptor is connected appropriately. Only use 12V car charger (for small car) and do not use 24V car charger (for truck) The environment temperature should be between 0°C and 35°C. To protect the electronic insides, the player will stop charging when too cold or too hot 1 Press and hold the POWER ON button on top of the player to switch on the set. 2 Insert a USB flash drive or USB memory card reader into the USB port. 3 The player will automatically browse and show the contents in the USB flash device. 4 Use navigation keys to select the file you want to access, then press OK to play it. 5 At the end of the playback, unplug the USB flash drive or USB memory card from the player 5.9 DTT Before installation, please make sure you are in an area with sufficient DTT signal coverage. You can check the signal coverage on country TV broadcast authority or visit 5.9.1 First Time Installation Antenna connection Before start the search the TV channel, connect the DVD player to the antenna as shown. Setup DTT channels During first time installation, you are prompted to select your country. 1 To confirm selection, press 2;. > After selecting your country, you are prompted to Auto Channel Search. 2 To start auto search, press 2;. > Auto channel search starts. 3 When Auto channel search is completed, the screen displays the total number of TV and Radio channels found. Select 2; to view programs of the first found channel. 5.9.2 Enjoy TV / radio programs On player • Press SOURCE to change to TV/RADIO. The sequence is DVD > TV > Radio > USB > AV-in • Press J( and )K to change channels • Use Vol + and Vol - to change the speaker volume With remote control • Press SOURCE to change to TV/RADIO. The sequence is DVD > TV > Radio > USB > AV-in • Press Ch + and Ch - to channels • Press Vol + and Vol - to change the speaker volume 5.9.3 Basic functions Manual Channel Search 1 Press SETUP > TV/RADIO > Manual search. 2 Select Channel number. To confirm a channel, press 2;. • Set Time Zone Select whether the local time offset with regard to Greenwich mean time is to be set automatically, or if you want to specify it yourself. To set local time, press SETUP, select TV/RADIO > Time settings. or plug converter Parental options are only selectable when password mode is deactivated. 5.9.4 On Screen Program Information INFO To view information of current program, press INFO. 1 : TV program : Radio program 2 Next program’s information 3 Program ...