Votes - 5, Average rating: 4.2
(
)
)
|
manual abstract
This is normal. The memory card is not malfunctioning. The memory card is designed to have a long life but after extended use you will not be able to delete from or write to it. Please purchase another. Write Protection of SD Memory Card Switch the write protect tab at the side of the card to “LOCK”. SDP93SWN_E_02-56.indd 24 2009/01/19 0 15:35:41 Preparations Preparations before using. • Preparation of the remote control • Power connection • Using the battery pack • To turn the LCD monitor • Powering on/off • Changing the mode SDP93SWN_E_02-56.indd 25 # 2009/01/19 15:35:41 I # Preparation of the remote control I Take care not to break your fingernail. 2k Place a coin-shaped battery (CR2025) with the © side up on the holder. Keep the holder horizontal so that the battery does not fall through. CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type. Insert the holder into the remote control. 3 26 The remote control battery contains Perchlorate Material - special handling may apply. See hazardouswaste/perchlorate Operating with the remote control Point the remote control at the remote sensor and press the buttons. Distance: About 3 m (9.9 feet) from the front of the remote sensor Angle: About 30° in each direction of the front of the remote sensor Do not expose the remote sensor of the player to a strong light source such as direct sunlight or other illumination. If you do so, you may not be able to operate the player via the remote control. • Do not drop or give the remote control a shock. • Do not leave the remote control near an extremely hot or humid place. • Do not spill water or put anything wet on the remote control. • Do not disassemble the remote control. • If the remote control does not function correctly or if the operating range becomes reduced, replace the battery with new one. • Inserting a battery other than the specified one or an object may damage the remote control. SDP93SWN_E_02-56.indd 26 2009/01/19 15:35:41 I # Power connection Connect the supplied AC adapter to wall outlet as below. CAUTION • Do not connect the power plug to a power outlet other than that indicated on the label, as this can result in a risk of fire or electric shock. • Do not connect or disconnect the power plug with wet hands. Doing so may cause electric shock. • Do not use an AC adapter other than one specified, as it can cause a fire or damage to the player. • When the AC adapter is in use, its temperature may increase. However, it is not a malfunction. Make sure that the AC adapter is disconnected and the temperature decreases before carrying it. I (D ~o £D To wall outlet Note • Do not use the supplied AC adapter with any device other than this player. 27 # SDP93SWN_E_02-56.indd 27 2009/01/19 15:35:41 Preparations Using the battery pack The supplied battery pack (lithium ion battery pack) can power the player for operation outdoors or in a place with no outlets. WARNING • Do not use a battery pack other than one specified as it can result in a fire or damage to the unit. • Do not heat, open, or short-circuit the battery pack. Do not throw the battery pack into a fire. Doing so may cause an explosion or a fire. • Attach the battery pack properly following the explanation below. Make sure that the battery pack is attached firmly to the player when using it. Otherwise, the battery pack may become detached and cause personal injury. ■ Attaching the battery pack 1 Turn the player off. 2 Disconnect all cables and cords from the player. 3 Turn the player upside down. 28 SDP93SWN_E_02-56.indd 28 4 Remove the connector cover on the bottom of the player. Remove the connector cover. (Be sure to attach it whenever the battery pack is not attached.) ♦ 5 Turn the battery pack over and insert four catches into the player’s corresponding holes CD- Then, slide the battery pack in the direction of the arrow (5) until a “click” is heard. 2009/01/19 15:35:42 # Important • Detach the battery pack from the player after being used. It is possible to leave the battery pack attached while powering the player with the AC adapter. ■ Charging the battery pack The battery pack needs to be charged before use. (The battery indicator ((CSl) is shown on the screen when the power in the battery pack is running low.) Perform a full charge before the first use. 1 Turn off the player. The battery pack cannot be charged when the player is on. Be sure to turn off the player before charging the battery pack. 2 Attach the battery pack to the player. 3 Connect the supplied AC adapter only to the player. Charging starts, and the POWER indicator illuminates in orange. When the charging...
DVD Players - SDP93SWN (901.65 kb)