• Do not operate your unit when the car battery is discharged. Peak current from the car generator may cause the DC fuse to blow. • If the vehicle’s supply voltage drops below approximately 10 volts, your unit may not work properly. • Do not leave your unit in a place where the temperature exceeds 70°C (158°F), or the pick-up device may be damaged. Examples include: - Inside a car with the windows closed and in direct sunshine. - Near a heating appliance. Automotive adapter • This automotive adapter operates on DC 8.5-16V. • Contact an electrical parts distributor for assistance in selecting a suitable automotive adapter. • Manufactured by WANLIDA Digital Technology Co., Ltd. Introduction 13 Power Connections (continued) Battery Pack NOTES • Do not detach the battery pack during playback. Charge the battery pack before using it for the first time. • Be careful not to drop the battery pack. A Detaching the battery pack A Attaching the battery pack a Press the PUSH knob. a Match the hooks of the battery pack into the holes on the bottom of the player. b Pull the battery pack until the hooks click. b Press and slide the battery pack until the hooks click. b b a a It balances the device so the unit will not fall backwards when you open the cover. Turn it counterclockwise after removing the batteries. Hooks ATTENTION The product that you have purchased contains The battery is recyclable. At the end of it’s useful life, under various state and local into the municipal waste stream. Check for details in your area for recycling options or proper 14 Power Connections (continued) A Charging the battery pack 1. Attach the battery pack to the player. 2. Connect the AC power adapter to the player and the plug into an AC outlet. Player Battery Pack Connect theAC Charge indicator adapter cord 3. During recharging, charge indicator is red. If recharging is complete, charge indicator changes to green color. CAUTION Take the following precautions to avoid liquid leakage, overheating, etc. • Do not use any unauthorized parts. • Use the authorized AC adapter when recharging battery. • Do not expose to high temperature above 60°C (140°F). • Do not attempt to dismantle or modify the unit. • Excessive impact may cause the unit to malfunction. • Do not incinerate. • Do not disassemble; dispose of properly. • Do not short-circuit. NOTE Charging a battery only happens when the power The battery will not be charged when it is naturally discharged. Because the unit cannot perceive even if you attached the battery. When you are in this situation, power off again. Then battery charge will proceed. A Recharging and play times Recharging without Playback Approx. 3.5 hour Play time Approx. 5.0 hours* * When Brightness control is set to initial mode. - using the headphones and volume center. - The playing time may be different depending on the kinds of disc. A Press “Display” to display the battery status on the screen. Full Low Recharge If using the AC adapter, battery display does not appear. If the battery capacity is not enough, “Check Battery Status” or “ ” is displayed on the screen and then the power is automatically turned off after a few minute. A If play time dramatically reduces after recharging The battery pack has reached the end of its service life (it can recharged about 300 times). A If the unit is not used for a long time • Detach the battery pack. (Even if the unit is off, it still uses some power. This can lead to over discharging of the battery and • Recharge the battery pack when you are ready Introduction 15 16 You can rotate LCD clockwise an angle of 180 degrees. However, if you turn it by force, it can cause serious damage. After rotating LCD completely, you can fold the LCD screen as shown above. Rotating the LCD Playing a Disc 1. Prepare the power supply. 2. Open the outer cover and press POWER button. 3. Press OPEN to open the disc lid and insert a disc with the side you want to play label up. Close the disc lid by hand. • If the disc is placed in upside down (and it is a single-sided disc), “CHECK DISC” or “DISC ERROR” appears on the screen. • After playing back all of the chapters in the title, the unit automatically stops and returns to the menu screen. 4. Press PLAY( N) to playback. Select a MODE Selects a mode among DISC, AV IN or USB. 1. Press MODE button on the unit. The mode selection menu appears on the screen. Introduction 5. Adjust the volume. 2. Use b / B to select the mode then press ENTER. NOTES • DISC: The disc menu or playback picture for the disc appears • Place a disc with the playback side down on the spindle, and on the screen . push gently on the center of the disc so it goes into position. • AV IN: A picture from external device appears on the screen. • If you are not using the LCD on this unit, select OFF to conserve power. • USB: A file or folder list in USB Flash Drive appears on the • The LCD is turned off if you close the unit. screen. • The picture shown on the LCD depends on the displa...