Votes - 0, Average rating: 0
(
)
)
|
manual abstract
The oven door hinges each have a locking lever. When the locking levers are closed (figure A), the oven door is secured in place. It cannot be detached. When the locking levers are open in order to detach the oven door (Fig. B), the hinges are locked. They cannot snap shut. $ % : Risk of injury! Whenever the hinges are not locked, they snap shut with great force. Ensure that the locking levers are always fully closed or, when detaching the oven door, fully open. Detaching the door 1. Open the oven door fully. 2. Fold up the two locking levers on the left and right (figure A). 3. Close the oven door as far as the limit stop. With both hands, grip the door on the left and right-hand sides. Close the door a little further and pull it out (figure B). 15 Attaching the door Reattach the oven door in the reverse sequence to removal. 1. When attaching the oven door, ensure that both hinges are inserted straight into the opening (figure A). 2. The notch on the hinge must engage on both sides (figure B). 3. Fold back both locking levers (figure C). Close the oven door. : Risk of injury! If the oven door falls out accidentally or a hinge snaps shut, do not reach into the hinge. Call the aftersales service. Removing the door cover The oven door cover can become discoloured. To carry out thorough cleaning, you can remove the cover. 1. Open the oven door fully. 2. Unscrew the oven door cover. To do this, undo the left and right screws (figure A). 3. Remove the cover (figure B). Make sure that the oven door is not closed while the cover is removed. The inner panel may be damaged. Clean the cover with a stainless-steel cleaning agent. 4. Replace the cover and secure it in position. 5. Close the oven door. Removing and installing the door panels To facilitate cleaning, you can remove the glass panels from the oven door. When removing the inner panels, pay attention to the sequence in which the panels are removed. In order to reassemble the panels in the correct sequence, use the numbers that appear on each panel. Removal 1. Detach the oven door and lay it on a cloth with the handle facing down. 2. Unscrew the cover at the top of the oven door. To do this, unscrew the left and right screws (fig. A). 3. Lift the top panel up and pull it out and remove the two small seals (fig. B). 4. Unscrew the retaining clips on the right and left. Lift the panel and remove the clips from the panel (fig. C). 5. Remove the seal from the bottom of the panel (fig. D). Pull the seal and remove it up and out. Pull out the panel. 6. Pull the lower panel at an angle, upwards and out. 7. Do NOT unscrew the left and right-hand screws from the sheet metal part (fig. E). Clean the panels with glass cleaner and a soft cloth. : Risk of injury! Scratched glass in the appliance door may develop into a crack. Do not use a glass scraper, sharp or abrasive cleaning aids or detergents. .. .. .. .. .. .. .. .. .. .. .. .. Installation During installation, make sure that the lettering "top right" is upside down at the bottom left of both panels. 1. Insert the lower panel at an angle towards the back (fig. A). 2. Slide in the middle panel (fig. B). $ % 3. Stick the retaining clips onto the right and left-hand side of the panel, aligning them so that the retaining carriers are over the screw holes, and then screw into place (fig. C). 4. Hook the seal in to the bottom of the panel again (fig. D). 5. Insert the uppermost panel at an angle to the back into the brackets. Take care not to push the seal to the back (fig. E). 6. Insert the two small seals on the left and right of the panel again (fig. F). ( ) 7. Put the cover back in place and screw it on. 8. Attach the oven door. Do not use the oven again until the panels have been correctly installed. & ' Troubleshooting Malfunctions often have simple explanations. Refer to the table before calling the after-sales service as you may be able to remedy the fault yourself. Malfunction table If a dish doesn't turn out as well as you had hoped, refer to the section Tested for you in our cooking studio, where you will find plenty of cooking tips and tricks. Problem Possible cause Remedy/information The oven does The circuit Look in the fuse box and not work. breaker is check that the circuit defective. breaker is in working order. Power cut Check whether the kitchen light or other kitchen appliances are working. 0 and three Power cut Reset the clock. zeros light up in the display. The oven does There is dust on Turn the control knobs back not heat up. the contacts. and forth several times. The oven door The oven door Wait until the oven has cannot be is locked by x cooled down and the H opened. The H self-cleaning. symbol goes out. symbol lights up in the display. Problem Possible cause Remedy/information The oven does The oven is in Switch off the circuit not heat up. The demonstration breaker in the fuse box and colon in the dis-mode. switch it on again after play flashes. approximately 20 seconds. Now, within approx. 2 m...