Votes - 5, Average rating: 4 ( )

Manafacture: Alesis File size: 2.91 mb File name: Language of manual:

• Plug the female end of the power cable into the GigaMix’s power socket. • Plug the male (plug) end into a properly grounded power outlet. Making Audio Connections Start by making sure the GigaMix’s power switch is turned off. Then use either 1/4” or XLR cables to connect your instruments and microphones to the GigaMix. After this, you may connect speakers to the GigaMix. There are several ways to do this: • Main (house) speakers. Connect two cables from the GigaMix’s two rear outputs to a matched set of speakers. For optimal power output, the total rated load of the speakers attached to these outputs should be 4 ohms. Note: the front panel Main Output jack(s) are not powered, and may be used to run the Main mix into another mixer for recording purposes. • Powered monitors (GigaMix 6FX and -8FX only). If you want to use the GigaMix to send a separate amplified signal to your monitors, first you must make sure that the front-panel Power Amp Mode switch is set to MAIN-MON. Then connect a cable from the GigaMix’s rear-panel Speaker Output 2 directly to the monitor speaker. It will carry the Monitor mix level. Note: You may daisy-chain several speakers, if necessary, as long as the total rated load of the speakers attached to this output is no lower than 4 ohms. • Unpowered monitors (all models). If you want to use an external amplifier to power your monitors, connect a cable from the GigaMix’s front-panel Monitor Output jack to a high-quality amplifier. Then connect the output of that amplifier to one or more monitor speakers accordin...

Download now

Please, enter two numbers from picture: