Votes - 5, Average rating: 4
(
)
)
|
manual abstract
If for some reason you are not happy details, including your telephone number, and with the service you receive, here are some send it to: steps to follow for further assistance. FIRST, contact the people who serviced your Customer Service appliance. Explain why you are not pleased. In Avanti Products most cases, this will solve the problem. 10880 NW 30 Street Miami, FL 33172 3 PARTS AND FEATURES 1. WATER INTAKE 6. REMOVABLE DRIP TRAY 2. COOL INDICATOR LIGHT (YELLOW) 7. FIXED FEET 3. COLD INDICATOR LIGHT (GREEN) 8. POWER SWITCH 4. COLD WATER FAUCET (BLUE) 9. VENTILATION GRILLE AREA 5. COOL WATER FAUCET (WHITE) 10. POWER CORD 4 Table Of Contents Registration Information ______________________________________________________________2 Help Us Help You_____________________________________________________________________3 Parts And Features ___________________________________________________________________4 Important Safety Instructions __________________________________________________________6 Installation Guidelines________________________________________________________________6 Operation Instructions ________________________________________________________________6 Before Using Your Water Dispenser_____________________________________________________6 Operating Your Water Dispenser_______________________________________________________7 Electrical Connection_________________________________________________________________7 Care And Maintenance________________________________________________________________7 Taking Dispenser Out Of Service _______________________________________________________8 Troubleshooting Guide________________________________________________________________8 Service For Your Water Dispenser______________________________________________________9 Your Avanti Products Warranty________________________________________________________ 10 Wiring Diagram _____________________________________________________________________ 11 Instrucciones En Espanol __________________________________________________________ 12-13 5 Important Safety Instructions • WARNING• To reduce the risk of fire, electrical shock, or injury when using your appliance, follow these basic precautions: ? ? ? ? Read all instructions before using the water dispenser. Never clean parts with flammable fluids. The fumes can create a fire hazard or explosion. Do not store or use gasoline or any other flammable vapors and liquids in the vicinity of this or any other water dispenser. The fumes can create a fire hazard or explosion Do not plug unit into receptacle until you ensure the water tank switch is off. -Save these instructions- INSTALLATION GUIDELINES ? Remove the exterior and interior packing. ? Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold ambient temperatures may also cause the appliance not to perform properly. ? Plug the appliance into an exclusive properly installed-grounded wall outlet. Do not under any circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power and/or grounding should be directed toward a certified electrician or an authorized Avanti Products service center. ? This water dispenser is not recommended for outdoor use. ? Do not locate the dispenser in area where the temperature may fall below freezing (32. F). ? Keep area around dispenser free of dust and dirt. ? Keep the reserve supply of water bottles away from excessive heat and light. OPERATION INSTRUCTIONS Before Using Your Water Dispenser ? The water cooler is pre-cleaned at the factory but the reservoir and water lines must be flushed with fresh water before use as follows: ? Keep the unit unplugged. ? Fill water tank with tap water full to capacity (about 20 ounces). Wait for 5 minutes until water settles. ? Proceed to drain the water from the faucets until no more water remains. ? Then, drain any water left in the tank by opening the water drain plug located on the bottom, until it drains completely. ? Proceed to close the drain cap. Also make sure both faucets are released completely. ? Place the water bottle on the water intake, allow water to stand for approximately one minute. ? Push both water faucets to insure water flows from both faucets, then release both faucets. ? Plug dispenser into the electrical outlet. ? Turn power switch ON (at the rear). ? Now you are ready to use your water dispenser. IT WILL TAKE APPROXIMATELY 1 HOUR TO REACH OPTIMUM TEMPERATURE. IF YOU CONSUME ONE 8 OZ. CUP THE RECOVERY TIME IS APPROXIMATELY 25 MINUTES OR LESS. IF YOU CONSUME 2 OR MORE 8 OZ. CUPS RECOVERY TIME CAN TAKE UP TO 1 HOUR. 6 NOTE: Your water dispenser has been cleaned and sanitized before leaving the factory, but in case a taste problem develops, place one tablespoon of baking soda and add tap water. Fill water tank again and repeat basic op...