|
Photos and specs Panasonic RN-202 |
manual abstract
Q Also, the tape speed will slow down, the sound will become distorted and the volume will decrease. ■ AC power operation m Connect only Panasonic AC adaptor (optional). To make recording |j_ Follow the steps 1-4 as figure S. Use a tape with tabs in place. The recording level is automatically adjusted. The built-in microphone is omnidirectional, so that recording is available in every direction. ■ To stop recording Press STOP/EJECT. ■ To temporarily stop recording Set the PAUSE selector to PAUSE. To resume recording, set it to OFF. ■ To recording through the external microphone (Only RN-502) Plug the external microphone (not included) into the MIC jack. Then follow the steps 1-4 as figure 11 ■ Silent auto-stop (Oniy RN-502) When the tape comes to its end during playback (or recording), the tape stops moving and the power is turned off. After that, be sure to press the STOP/ EJECT Button. ■ To record for a long time Set the TAPE SPEED selector to 1.2. • It is recommended 2.4 position for better sound Quality. ■ To play the desired tone (Only RN-502) Set the TONE selector to HIGH or LOW. ■ To fast forward and rewind Press FF/CUE (fast forward) or REW/REV (rewind). Note: When the tape reaches the end, press STOP/ EJECT to release the button and turn off the unit. ■ Cue and review Sound can be monitored at a high speed for as long as the FF/CUE (cue) or REW/REV (review) is held down during playback. When the button is released, normal playback will start. ■ Tape counter and reset button (Only RN-502) The digits returns to "000" when the reset button is pressed. The digits advance with the tape to provide a reference to quickly find a desired portion of tape. Notes •Avoid using or placing this unit near sources of heat. Do not leave it in an automobile exposed to direct sunlight for a long period of time with the doors and windows closed, as this may deform the cabinet. • Do not bring magnetized commuter passes, credit cards, recorded tapes, etc., close to the monitor speaker. •When not in use, disconnect the AC adaptor from the AC power outlet. To prevent possible damage to this unit •Load new battery with their polarities (© and 0) aligned correctly. •Do not apply heat to batteries, or internal shortcircuit may occur. •If this unit is not to be used for a long period of time, or used on AC mains supply, remove the batteries and store them in a cool and dry place. •Remove spent batteries immediately. •Do not use old and new batteries together. Also never use an alkaline battery with a manganese battery. ■ Head care Q To ensure good sound quality, be sure to clean the head after approximately every 10 hours of use with a cotton swab dampened with a little alcohol. ■ To record with VAS (Voice Activated System) function (Only RN-502) The sound is recorded automatically, so there is no tape waste. To use VAS function, select VAS in step 2 and adjust the VAS LEVEL. 1-3: If you wish to record only the louder ...
Other models in this manual:Dictaphones - RN-502 (284.59 kb)