51 Localiser les ouvertures du sillon au bas du couffin. Busque las aberturas del canal en la parte de abajo del moises. Insert tube with plastic end into channel openingA. Snap buttons should be down as shownB. A 52 Inserer le tube comportant l’extremite de plastique dans l’ouverture A du sillon. Les boutons a pression doivent etre orientes vers le bas, tel qu’illustre en B. Pase el tubo con el extremo de plastico por la abertura del canal A. Trabe los botones como se indica en B. B NOTE: DO NO

NOTE: Brake levers must face rear of stroller. Rear Wheel Assembly Fold Locks Cross Tube ASSEMBLY continued 3 Secure Wheel to Axle as shown: • Push Connector onto Axle with Ribs facing in. • Slide Wheel onto Axle and push into Connector. • Slide Wheel Retainer onto end of Axle. Make sure large end of Wheel Retainer is towards Wheel. Wheel Retainer should snap into groove on end of Axle. • Snap wheel Retainer Cap over Wheel Retainer. • Line up Hub Cap tabs with slots in Wheel and snap Hub Cap in

DEDICATED TO QUALITY IMPORTANT INFORMATION Table of Contents Page: 1 Important Information 2 Warnings 3 Assembly and Use Playard Bassinet Changer 7 Folding and Storing Changer Bassinet Playard 9 Maintenance Cleaning 9 Replacement Parts Need Help? If you should have any problems with this product, call toll-free 1-800-837-4044 from anywhere in the U.S. or Canada or fax at 1-610-286-4555. Or write us at: Century Products P.O. Box 100 Elverson, PA 19520-9974 Attention: Customer Service Department P

DEDICATED TO QUALITY Read all instructions BEFORE assembly and USE of this product. KEEP INSTRUCTIONS FOR FUTURE USE. Store in pocket on bottom of floorboard. IMPORTANT INFORMATION This product can be used as a Playard, Bassinet, Changer or Sleeping Crib. Table of Contents Page: 1 Important Information 2 Warnings 3 Assembly and Use Playard/Crib Bassinet Changer Canopy 8 Folding and Storing Canopy Changer Bassinet Playard/Crib 11 Maintenance Cleaning 11 Replacement Parts Need Help? If you should

NEVER use additional mattress or padding. Floorboard ASSEMBLY and USE continued 5 Insert one side of floorboard Pocket under Pocket on side of bassinet. Pockets 6 Pull Pocket down over floorboard to hold floorboard in place. Repeat steps 5 and 6 for other side of floorboard. 7 Push down on center of floorboard to flatten. Bassinet assembly is now complete. • Bassinet can be used with or without Playard/Crib. To use bassinet with Playard/Crib: Place bassinet in center of Playard/Crib so that hook

4 Read and understand instruction booklet before using bassinet. 4 Do not use in any vehicle. c Need Help? 4 Never leave baby unattended. If you should have any problems with this product, call toll-free 1-800-837-4044 from anywhere in the U.S. or Canada. Outside these areas please call 216-963-2800 4 Do not use accessories other than those provided by manufacturer. 8:00 AM until 6:00 PM E.S.T. Monday through Friday. c Weight Limit: Or write us at: Century Products CompanyMaximum Weight: 18 lbs.

It is advisable to set up only on soft surfaces like grass or sand. Secure 4 corners of product to the ground with the pegs provided and/or fill side pockets with sand. Pour obtenir une utilisation maximale de votre produit , ne pas l'installer sur du beton ou sur des surfaces irregulieres car le tissu en polyester autour de l'armature pourrait se dechirer. Il est recommande de l'installer seulement sur des surfaces souples comme l'herbe ou le sable. Fixez les 4 coins du produit au sol avec les